answersLogoWhite

0

your acceleration peddal is jammed take it to a local mechanic and it should cost about 500 at the most at the least 100

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace accelerator pedal sensor 2000 Isuzu trooper?

Remove two 10mm bolts supporting the pedal. Disconnect the electronic unit connected to the pedal using a small flat head screwdriver. Take off two phillps screws attached to the unit.


What would make your mondeo tdci have a flat spot and only when driving at 55 to 65 mph?

Flat spots occur due to several reasons. It could be leaks in the accelerator pump piston or the accelerator pump valves. It can occur when you are accelerating because there is a momentary hesitation from the engine after the pedal is pressed down.


Is it top-floor flat or top floor flat?

top floor flat


What does it mean when you can press the brake pedal to the floor with ease?

You don't have brake fluid There could be air in the system and it requires bleeding to rid it of air. If the vehicle is an older one, the master cylinder may be porus or the bore pitted. It should be resleeved or replaced. The seals could also be flat. Jam your foot down hard on the brake pedal. Is the pedal high? Does it sink to the floor if you rest your foot lightly on the pedal? www.powerbrakeandsteering.co.za


How do you lye on the floor?

get on the floor put your back on it and lay flat with your feet out


What is another name for flat surface?

A floor.


What are the benefits of using a flat and clipless pedal combo for cycling?

Using a flat and clipless pedal combo for cycling offers benefits such as increased power transfer, better efficiency, improved control and stability, and reduced foot fatigue. This combination allows for a more secure connection between the foot and pedal, resulting in a smoother and more efficient pedal stroke.


What is the answer to del boys flat number?

I'm not sure what number his flat was but he lived on the 15th floor.


What is a broad flat valley floor cut by?

A stream


What is a pedal wrench and how is it used in bicycle maintenance?

A pedal wrench is a tool used to remove and install pedals on a bicycle. It has a long handle and a thin, flat head that fits into the pedal's axle. To use a pedal wrench, you place the wrench on the pedal axle and turn it in the direction needed to loosen or tighten the pedal. This tool is essential for maintaining and repairing bicycles.


Mitsubishi 6A12 powered car.its a quad cam 24 valve 2.0 liter engine problem is when i try to accelerate hard from about 2500rpm the engine dies i think the distributor but i am not sure?

If it only happens when you put your foot flat on the throttle pedal, it could be that your throttle cable is too tight. You can test this by depressing the throttle pedal to just before you hit the floor, if that works, try adjusting the throttle cable with the two 10mm bolts on top of the intake manifold. If that doesn't work then I can't help. Sorry. Mike


When taking a throw in do both feet have to be flat on the floor?

yes