answersLogoWhite

0

To remove the caliper on a Dodge 2000, you typically need a 3/8-inch Allen wrench (also known as a hex key). However, it's important to check the specific model and year, as variations may exist. Always consult the vehicle's service manual for the most accurate information.

User Avatar

AnswerBot

1d ago

What else can I help you with?

Related Questions

What size wrench does it take to remove brake caliber on 2000 Dodge Dakota?

I haven't done any in a while but it is most likely the same as durango which is a 7mm Allen socket


What size Allen wrench do you need to change front brakes on your 2000 ford focus?

I don't think that's Allen. It may be 13mm wrench. -Have small wrench set and Allen set ready and you are prepared.


What size is the allen wrench needed to remove the front brake pads on a 2000 Mazda 626?

I think that is a 14 mm open wrench, not Allen.


What size Allen wrench do you use to change front brakes on a 2000 cougar?

You need a torx type socket. If you use an Allen wrench...you will strip out the inside of the bolt.


What size Allen wrench to take off caliper on 2000 Chevy Silverado?

A 3/8 Allen key.


What size Allen wrench do you need to change front brakes on 2000 dodge durango?

I had the same issue of getting the right size so I called up a Dodge dealership. They said use a 7mm hex (or allen). Not a typical size, but you should be able to find it at a Sears in the wrench type or socket (which I prefer). It should only cost a couple of bucks, around $5 tops.


How do you remove 2000 dodge b1500 van seats?

Use a wrench to unbolt them.


What size of Allen wrench do you need to take off brakes for ford focus 2000?

You need 7 mm Allen key


What size wrench to loosen caliper bolts on 2000 Passat?

Should be 10mm or 3/8ths Actually, it turned out to be 7mm Allen wrench.


What size Allen wrench to remove the front brake calipers on a 2000 ford focus?

7mm


What size Allen wrench is needed for front brake caliperfor ford 2000 contour?

It's a 7


Wrench size to use on 2000 dodge neon drain plug?

If it's the "oil" drain plug, the size wrench is, better yet use a socket wrench=13mm.