Remove seat(saddle) battery is located under seat.
Find your battery. Remove the negative post first. Then positive. Install new battery. Hook up positive post first, then negative. VROOM!
Remove the screw at the back of the back seat, then the two screws that hold down the front seat and there is your battery. Please remove the negative cable first.
Remove seat, un bolt the battery, pull up and remove. Put a new one in, bolt the two knots and replace the seat!
how do you remove front tire on 02 softail springer
I have an 03 soft tail ... the fuse box is just rear of the battery ..... the battery and fuse box are under the seat .... you'll need to remove the seat to get to it ....
To remove the starter from a 1987 Harley Davidson Softail, first disconnect the negative battery cable to ensure safety. Then, remove any components obstructing access to the starter, like the exhaust or primary cover, if necessary. Next, disconnect the wires from the starter, noting their positions, and remove the mounting bolts securing the starter to the engine. Finally, carefully pull the starter out of its housing.
How do you change oil in a 2000 heritage softail? Are there 3 plugs to remove or just two?
To remove the gas tank from a 2006 Harley Softail, first ensure the bike is on a stable surface and disconnect the battery to prevent any electrical issues. Next, drain the fuel from the tank, then remove the seat and any side panels as needed. Disconnect the fuel line, vent line, and any electrical connections to the fuel gauge, and finally, unscrew the mounting bolts securing the tank to the frame. Carefully lift the tank off, taking care not to damage any surrounding components.
unhook your battery. remove sensor. no setting is needed.
To remove the ignition switch from a 1989 Caprice Classic, start by disconnecting the negative battery cable to avoid any electrical issues. Then, remove the steering column covers by unscrewing the screws. Once exposed, locate the ignition switch, disconnect the wiring harness, and unscrew the ignition switch from its mounting. Finally, pull the ignition switch out of the column and replace it as needed.
well, the battery is in the trunk. you need to remove the strap that holds the battery in, after, remove the negative then the positive terminal. wah-la! its out :D reverse to put it back. if needed, clean with baking soda.