To remove the starter from a 1987 Harley Davidson Softail, first disconnect the negative battery cable to ensure safety. Then, remove any components obstructing access to the starter, like the exhaust or primary cover, if necessary. Next, disconnect the wires from the starter, noting their positions, and remove the mounting bolts securing the starter to the engine. Finally, carefully pull the starter out of its housing.
Remove the starter. the solenoid is mounted on the starter.
On a 1991 Harley-Davidson Heritage Softail, the starter relay is typically located under the seat, mounted to the frame. To access it, you'll need to remove the seat and possibly the side cover. The relay is usually a small cylindrical or rectangular component connected by wiring to the battery and starter motor. Always refer to the service manual for your specific model for detailed instructions.
you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.
Remove seat, un bolt the battery, pull up and remove. Put a new one in, bolt the two knots and replace the seat!
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
The 2003 Harley-Davidson Heritage Softtail transmission drain plug is on the bottom of the transmission. The drain plug is flush with the bottom of the transmission. You can remove it with a half inch ratchet.
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
To remove a 1987 Harley Davidson starter motor, first disconnect the battery to prevent any electrical shorts. Then, locate the starter motor, usually mounted near the engine, and remove the bolts securing it to the engine. Disconnect the wiring harness and carefully pull the starter motor out of its mounting location. Finally, ensure all connections are clear and check for any debris before installation of a new starter, if necessary.
how do you remove front tire on 02 softail springer
Disconnect battery negative terminal, drain primary chaincase, remove left foot board & its rear bracket, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
To replace the starter on a 1988 Heritage Softail Custom, first disconnect the battery to ensure safety. Remove the primary cover and drain the primary fluid, then take off the primary chain and clutch assembly if necessary to access the starter. Unbolt and disconnect the old starter from the mounting plate and electrical connections, then install the new starter by reversing the steps. Reassemble the primary components, refill the primary fluid, and reconnect the battery.
how do i replace the bendix drive in my 85 harley fxrs