answersLogoWhite

0

how do i replace the bendix drive in my 85 harley fxrs

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you change starter solenoid on a Harley Davidson?

Remove the starter. the solenoid is mounted on the starter.


How do you remove starter Harley Davidson Fatboy 1998?

you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.


How do you replace a stator on a 1995 Harley road king What does the stator do?

Remove the cables from the 1995 Harley-Davidson Road Tank motorcycle starter. Remove the retaining bolts. Reverse the process to install the new starter. The starter turns the engine over so it can start.


How do you remove the starter haarley Davidson softail 1987?

To remove the starter from a 1987 Harley Davidson Softail, first disconnect the negative battery cable to ensure safety. Then, remove any components obstructing access to the starter, like the exhaust or primary cover, if necessary. Next, disconnect the wires from the starter, noting their positions, and remove the mounting bolts securing the starter to the engine. Finally, carefully pull the starter out of its housing.


How do you remove a 1987 Harley Davidson starter motor?

To remove a 1987 Harley Davidson starter motor, first disconnect the battery to prevent any electrical shorts. Then, locate the starter motor, usually mounted near the engine, and remove the bolts securing it to the engine. Disconnect the wiring harness and carefully pull the starter motor out of its mounting location. Finally, ensure all connections are clear and check for any debris before installation of a new starter, if necessary.


How do you remove starter on 1993 Harley Davidson FXR?

You buy a service manual and study it very carefully. It's worth it, cost is about $30.


What would cause the starter in a 92 ford escort to not disengage?

the bendix gear on the starter is stuck on the flywheel remove starter check bendix gear for wear if worn to bad replace starter


How do i repair a starter on a 1988 Harley Davidson flhtc?

simply put, buy a repair manual; you are going to need it. Be prepared to remove the primary cover.


How do you remove the starter on 1987 Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you remove a starter from a 1998 Dyna Harley Davidson?

Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.


How do you replace the starter clutch on a 2010 harley-Davidson street glide?

To replace the starter clutch on a 2010 Harley-Davidson Street Glide, first, remove the primary cover by draining the primary fluid and disconnecting the necessary components. Then, remove the clutch assembly and the starter gear to access the starter clutch. Replace the faulty starter clutch with a new one, ensuring proper alignment, and reassemble the components in reverse order. Finally, refill the primary fluid and check for proper operation.


How do you replace starter on 85 Harley Davidson FXWG?

To replace the starter on an '85 Harley Davidson FXWG, first disconnect the negative battery cable to ensure safety. Remove the starter's mounting bolts, disconnect the electrical connections, and carefully pull the starter out. Install the new starter by reversing the process: connect the electrical connections, secure it with the mounting bolts, and reattach the negative battery cable. Finally, test the starter to ensure it operates correctly.