A shorted or grounded coolent sensor, A bad computer.
Is check engine light on ? if so have engine scaned by a good shop
and they can tell you whats up.
This tranny has a the feature of putting itself into "limp" mode when it senses a problem with itself. Limp mode is full-time second gear.
No. However, it can cause the car to run in "limp home" mode. No. However, it can cause the car to run in "limp home" mode.
Full Screen Mode: the F11 key toggles Full Screen Mode on and off.
It would be bypassed by the mode door in the ducting under the dash. You may have have a problem with your mode door if your compressor is turning on when you select A/C. If the compressor clutch does not engage it is likely that there is an insufficient charge in the system, and you may have a leak.
There is a problem with the transmission, And the computer see's it and put the transmission into the FAIL SAFE MODE to stop it from blowing apart.You need to quit driving it and get it to a transmission shop ASAP.
ANSWER: The Default Mode is Author Mode and it allows full access.
Usually function key F11 toggles full-screen mode on & off.
the mode is the most common number for example 89,56,78,8,32,64,8 8 would be the mode you get it cause its the most common In math, mode means most used. So if you see a chart graph and you see some number that is the highest used, then that number would be the mode.
the mode is the most common number for example 89,56,78,8,32,64,8 8 would be the mode you get it cause its the most common In math, mode means most used. So if you see a chart graph and you see some number that is the highest used, then that number would be the mode.
The car will start and run poorly in the limp mode and the check engine light will illuminate.
If you are getting a code 38 on a 1992 Chevy van, it means that the brake switch is stuck in stop mode. This will also cause your cruise control to not disengage when you press your brake pedal.
if it has the tow haul mode that is probably what is causing it , the trans is designed to do that to reduce slipping when it shifts , this reduces the wear on the clucth packs an the it will last a lot longer