0
What else can I help you with?
Where is the Oil sending unit on a 89 S-10 Blazer?
You have to specify which engine. On my 1991 pickup with a 2.8 L V6 it's next to the oil filter. It's a 4.3 L V6, 89 S-10 Blazer!! Sorry about that!!
Where is the Oil sending unit on a 89 S 10 Blazer?
You have to specify which engine. On my 1991 pickup with a 2.8 L V6 it's next to the oil filter. It's a 4.3 L V6, 89 S-10 Blazer!! Sorry about that!!
Where is the Oil Pressure Sending Unit located on a 1990 4.3 Chevy S-10 Blazer?
The oil pressure switch is directly behind the carburator. Between the distributor and the carb.
Where does the hot wire lead to from the sending unit on a 1986 Chevy s-10 pickup?
Which sending unit? Oil pressure sending unit? Engine temp sending unit? Fuel gauge sending unit?
How do you replace the oil sending unit on a 1992 Chevy Blazer S-10?
Oil sending unit is under intake manifold, just behind the oil filter on the passenger side (difficult to see-use flashlight). Best option to change : Get everything to do an oil change, removal of the filter makes easier access.Read more: Where_is_the_oil_sending_unit_on_2000_Chevy_S-10_2.2
Where would the oil sending unit be found a 1993 Chevrolet S-10 blazer?
UNDER HOOD, DRIVER SIDE, FRONT ENGINE AREA, BELOW EXHAUST MANIFOLD, MOUNTED IN ENGINE BLOCK.
Where is the sending unit fuse on a 1997chevy s-10 with a 2.2L engine?
Need to know which sending unit, there are several, oil, temp, fuel,
Can the oil sending unit cause the fuel pump to not get fuel to the throttle body of a 1988 Chevy S-10 pickup?
YOUR ANSWER WILL MOST LIKELY BE A ''NO'' THE ''OIL'' SENDING UNIT DOES NOT HAVE ANYTHING TO DO WITH THE FUEL. (JUST OIL) THE JOB OF THE SENDING UNIT IS TO LET THE DRIVER KNOW THE HOW THE LUBRICATING SYSTEM IS WORKING.EX. LOW OIL PRESSURE ,OIL LEVEL IS LOW, HIGH OIL PRESSURE ETC THE SENDING UNIT WILL SENSE THE "CHANGE" IN THE LUBRICATING SYSTEM AND TURNS ON THE OIL LIGHT IN THE DASH BOARD.
Where is the Oil pressure sending unit on a 1990 F250?
Just foward and at the 10:00 position from the oil filter.
Where is temperature sending unit on 2001 S-10 Blazer?
On a 2001 S-10 Blazer, the temperature sending unit is typically located on the engine block, near the thermostat housing. It is usually positioned on the driver's side of the engine, threaded into the intake manifold or cylinder head. To access it, you may need to move some components or hoses out of the way.
Where is the oil sending unit on a 93 s-10 pickup 2.8 Lt?
on a 2.8 Lt engine its by the oil filter
Why is there power to the fuel pump on your 1990 Chevy blazer but it will not pump?
Bad fuel pump?or bad relay,when you first turn on the key,the pump should purge fuel to start for around 5-10 seconds then when you car starts there is a oil/fuel sending unit that screws into the block behind the distributor,this will allow your fuel pump to work once your motor has oil pressure,if you have no or low oil pressure the sending unit will not supply 12 volts to the pump,the relay works when you first turn the ignition switch on then the sending unit takes over
