On a 5HP Briggs and Stratton engine, timing marks are typically found on the flywheel and the engine block. Look for a notch or a mark on the flywheel, which aligns with a corresponding mark on the engine block when the piston is at top dead center (TDC). These marks help ensure proper timing during assembly or maintenance. Always refer to the specific engine model's service manual for detailed guidance.
.030
1ml
SAE 30
Run the car good
All the small Briggs engines seem to have a points gap of 0.02 inches
any where from 120 lbs to 180 lbs
The spark plug should be gaped at .030"(76mm)
A Champion CJ8Y or J19LM will perform fine
0.030" for a champion or 0.020" for NGK and others.
It may be one of two things. Either it isn't getting enough gas, or to much
The most common reason for a carburetor not to receive fuel is a plugged fuel line. The fuel filter can also be plugged.
The easiest way is to use a standard business card between the coil and the magnet part of the flywheel.