answersLogoWhite

0

On the cam pulley, and the back of the head are two marks that should be alligned 0762646447 after hours

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you set Ignition timing on Honda goldwing 1100?

To set the ignition timing on a Honda Goldwing 1100, first, ensure the engine is at operating temperature and then turn it off. Remove the timing inspection cover and connect a timing light to the number one spark plug wire. Start the engine and point the timing light at the timing marks on the crankshaft and engine case; adjust the timing by loosening the ignition timing adjustment screw and rotating the ignition plate until the marks align at the specified RPM, usually around 1,000 RPM. Finally, tighten the adjustment screw and recheck the timing to ensure it remains in alignment.


How do you set the timing on a virago 1100?

To set the timing on a Virago 1100, first, ensure the engine is at top dead center (TDC) on the compression stroke for the front cylinder. Remove the timing inspection cover and check the alignment of the timing mark on the rotor with the reference mark on the stator. If adjustments are necessary, loosen the screws on the pickup coil and rotate it slightly until the timing marks align, then retighten the screws. Finally, recheck the timing to ensure it is correctly set before reassembling.


How do you set timing on 2002 Yamaha V-star 1100?

timing is fixed; controlled and monitored by the igniter unit and cannot be adjusted.


Why does your 1999 Dodge truck timing stay 35 degrees advanced at 1100 rpm?

The computer controls the timing. It will move it where it wants.


Why does your 1999 dodge ram truck timing stay 35 degrees advanced at 1100 rpm?

The computer controls timing, it will set it where it wants.


What is the value of a 28 gauge Remington 1100 in excellent condition?

verry good no marks on stock or metel


How meny kilometers you change fiat uno 1100 timing belt?

i think it is safe to do it every 60 000k


How many total marks in fbise hssc?

In the Federal Board of Intermediate and Secondary Education (FBISE) for the Higher Secondary School Certificate (HSSC) exams, the total marks vary depending on the subjects. However, in general, the total marks for HSSC exams typically range from 1100 to 1200 marks.


What percentage would you score if you answered 930 questions correctly out of 1100?

Assuming all answers carry equal marks, the answer is 84.5454... %


What would make a 350 chev carby backfire at 3000rpm but only while in gear?

The most common reason for backfire in an engine is the timing is not set correctly. The bad timing could also be caused by the timing chain beingworn out or a camshaft that is worn out. Get a timing light and check to see what the timing is set to. It should be around 8 to 12 degrees before top dead center at idle(800-1100 RPM) with the distributor's vacuum advance disconnected for most Chevy small blocks. There should be a sticker in the engine compartment that gives the idle speed and timing spec. for that model. If there is not sticker, the spec. above should correct your problem if the parts mentioned are in good condition (not worn out).


What are Total marks of FSc-pre medical Multan Board 2009?

The total marks for the FSc (Faculty of Science) Pre-Medical program under the Multan Board in 2009 were 1100. This typically includes marks from three core subjects: Biology, Chemistry, and Physics, each carrying 100 marks, along with additional marks from practicals. The overall assessment also includes marks from the intermediate examinations.


Timing for a 1972 olds 350?

350 cu in with 2 barrel carb, 8 degrees at 1100 rpms 350 cu in with 4 barrel carb and standard transmission, 8 degress at 1100 rpms 350 cu in with 4 barrel carb and automatic transmission, 12 degrees at 1100 rpms