Your JOHN DEERe dealer would be a good place to start but if they no longer have the part available try the guys in the related link...
To check the hydraulic level on a John Deere 2030, locate the hydraulic reservoir, which is typically found near the rear of the tractor. Remove the dipstick or filler cap and wipe it clean, then reinsert it without screwing it in to get an accurate reading. The fluid level should be between the "Add" and "Full" marks on the dipstick. If needed, add the appropriate hydraulic fluid to reach the proper level.
The hydraulic fluid reservoir on a John Deere 2030 typically holds about 8 to 9 gallons (30 to 34 liters) of hydraulic fluid. It's important to check the owner's manual for specific details and maintenance guidelines. Proper fluid levels are essential for optimal hydraulic system performance.
lift the seat and pull the dipstick while warmed up and running.
10 Gallons total The hydraulic oil is shared with the Differential and Transmission.
We had a 2030, and used 3 16in plow bottoms, but you probably could do 4 depending upon your soil, rocks ect.
John Deere's parents were William and Sarah Deere.
JOHN DEERe's parents were William and Sarah Deere.
john deere
Most John Deere products are made by.... John Deere.
Proper names are the same in spanish..."John Deere" is John Deere.
To add oil to the transmission of a John Deere L120, first ensure the mower is on a level surface and the engine is off. Locate the transmission dipstick or fill cap, usually found near the rear of the mower. Remove it, then use a funnel to add the appropriate type of transmission fluid until it reaches the recommended level on the dipstick. Finally, replace the dipstick or fill cap securely before starting the mower.
john deere