The EGR valve is located on the back side of the valve cover on driver's side. It is connected from the rear of the valve cover into the intake manifold's plenum chamber, again on the drivers side.
P0400....Exhaust Gas Recirculation Flow P0401....Exhaust Gas Recirculation Flow Insufficient Detected I can't find any that has a .1
look at the head with the valve cover off find where the exhaust manifold goes in tha is the exhaust valve or looking at the valves the first one is exhaust then intake then intake ,exhaust,exhaust,intake,intake,exhaust if you have the head off i think the intake valves are bigger than the exhaust
You can find the PCV valve for your 1997 Mitsubishi Montero on top of the engine. The PCV valve will be in front of the air cleaner housing.
The exhaust lifters will line up with the exhaust manifolds,Remove the valve cover if your working on a V8 and the valve that lines up with the exhaust port will be the exhaust valve,If it is a Chevy V8 they will be from standing in front of the car exhaust,intake,intake,exhaust,exhaust,intake,intake,exhaust.
You can obtain a wiring diagram of your Mitsubishi 1.5 liter at most Mitsubishi dealerships. You can also find the wiring diagram and many auto-parts stores.
Gonna have to pull the head and find out what's wrong. Could be a bent valve.
24 valve 2.0 litre
front valve cover at the left back corner. It screws in to the valve cover. There is a rubber hose conected to it.
The circuit range should be between 3.4 and 4.5. Anything above 5 or below 3 is not performing correctly.
The EGR (Exhaust Gas Recirculation) valve on an Oldsmobile Silhouette is typically located on the engine, often near the intake manifold. To find it, look for a metal or plastic component connected to a vacuum line and electrical connector. The exact location may vary depending on the specific engine model and year, so it's best to consult the vehicle's service manual for precise details.
either a forge 004 blow off valve or a forge splitter, a partial blow off valve and partial recirculation valve. which is what i run on my a4. you may be able to find better prices of these somewhere else online, i never checked,
I have a 97 Mitsubishi Galant and the exhaust is sucking air back into the car instead of expelling them. What could be the possible problems. My thoughts suggest you get a motor-mechanic to find out...