0
What else can I help you with?
Do 1987 350 Chevy vans have electronic ignition?
Yes they do.
Proper spark plug gap for 1985 Chevy 350 with electronic ignition?
It is .045
How do you wire an ignition for a Chevy 350?
Bolt The Coil Bracket And Coil To The Block, The - Goes To The Distributor The + Hooks To The Ignition.
What is the timing on a 350 Chevy small block with electronic ignition?
4, or 6 degrees advanced, or BTDC, depending on your altitude.
Where is the timing supposed to be for a 94' Chevy 350 with HEI ignition?
around 6-8 degrees with the vacuum advance blocked off. electronic ignition has no vacuum advance! How does one blank off the electronic advance???
How do you wire a 75 350 changing from old dist to electronic ignition for the new dist?
I've never seen a 75 Chevy 350 that didn't come with HEI, as it was a mid-year introduction in 1974. However, if such a thing as a 75 Chevy with point distributor exists, there would be a steel wire running from the ignition switch to the hot side of the coil. The steel wire would need to be replaced with a copper wire. The steel wire acts as a resistor to reduce the voltage to the coil, which is not necessary on an HEI, and would limit the total voltage the coil could produce.
How can you wire a chvy 350 motor up to run?
It depends on the year of the vehicle, whether it's throttle body injected, electronic ignition...
The Firing order for 1979 Chevy truck with 350 with electronic ignition?
1, 8, 4, 3, 6, 5, 7, 2.
On a Chevrolet 350 does an electronic ignition have points?
No it does not have points or condenser.
What is the firing order for a 1973 Chevy 350 with HEI ignition?
1.8.4.3.6.5.7.2
What is the ignition timing for a 72 Chevy 350?
8-10 degrees
On a 1987 Chevy pickup 350 what wire is used for a tach not hei?
For a 1987 Chevy pickup with a 350 engine and a non-HEI ignition system, the wire that is typically used for connecting a tachometer is the green wire located on the distributor cap. This wire provides the signal needed for the tachometer to work accurately. Make sure to consult the vehicle's manual or a wiring diagram to locate the specific wire on your truck.
