In the Fiat Palio 2, the ignition coil is typically located near the engine, mounted on or near the cylinder head. It is often positioned close to the spark plugs for efficient ignition. Depending on the specific engine model, you may need to remove engine covers or other components for easier access. Always consult the vehicle’s manual for precise location and removal instructions.
where can I see the fly wheel mark for fiat palio 1.2
The ignition coil is inside the distributor....
second coil pack back from the front on passenger side
the number 2 ignition coil in a 2006 hyundai sonata is the middle in the front three ignition coils
underneath the plastic cover on the engine head are the spark plug wires, there are 2 coil packs there. the wires connect the coil packs. 2 of the spark plugs are under the coil packs and the other 2 are exposed...
To fit the HT leads to the coils of a Fiat Punto, start by ensuring the engine is off and cool. Begin with the coil pack, connecting the leads in the correct firing order, which typically is 1-3-4-2 for the Fiat Punto's engine. Make sure each lead is securely attached to both the coil and the corresponding spark plug. Finally, double-check that the leads are routed correctly to avoid any contact with hot engine parts.
The Ignition Control Module (ICM) is located directly above the coil. If you remove the 2 bolts holding the coil on and then romove the coil mounting plate from the car you will see a small rectangular module with wires plugged into it. This is the ICM.
Coil 2 is located where the other seven are found (if you have a V8). Underneath a cover on the valve covers. Yes the valve covers have a small wide cover that houses the COP coil plugs. Each cylinder has it's own spark plug with a coil. hope this helps. ps.from the front- left(driverside) 5-6-7-8 right ( passengerside) 1-2 -3-4
Under the coil,check link below:
cop- coil on plug - each spark plug has an individual coil mounted on top -------------------------------------------------------------------------------------------------- actually , EDIS ( Electronic Distributorless Ignition System ) The coil pack ( with 6 towers ) on your 1992 Ford Explorer is located above the passenger side valve cover of your engine The coil pack towers are numbered : coil----3---4 pack---2---6 plug----1---5
This is located on the outdoor coil. It is usually toward the bottom of the condenser coil and will have 2 wires attached to it. These wires come from the sensor and go into the defrost control board. It is a disc and is easily removed from the coil.
On a 1996 Mercury Grand Marquis with the 4.6 liter SOHC , V8 engine : There are ( 2 ) coil packs with ( 4 towers on each ) They are located at the front area of the engine , just follow the spark plug wires to each of the ( 2 ) coil packs