answersLogoWhite

0

Standing in front of the vehicle looking at the engine the rear cylinders are numbered from left to right 1-3-5 and the front cylinders left to right are 2-4-6. Firing order is 1-2-3-4-5-6. Coil pack connections left to right are:

5-2 3-6 4-1

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you replace the fuel filter on a 1999 Oldsmobile silhouette?

replace a fuel filter on a 1999 Oldsmobile Silhouette


Where is the Automatic Level Control located on a 1999 Oldsmobile Silhouette?

It is located at the rear of the van on the driver side behind the gas tank


Where is the starter located on 1999 Oldsmobile silhouette?

On a 1999 Oldsmobile Silhouette, the starter is located on the driver's side of the engine, near the transmission. It is positioned towards the rear of the engine block, beneath the intake manifold. To access it, you may need to remove some components or shields in the area for better visibility and space.


Where is the EGR valve located on a 1999 Oldsmobile Alero with a 2.4L cylinder?

no egr valve on 1999 to 2001 2.4 alero


Where is the camshaft sensor on a 1999 Oldsmobile silhouette?

behind the power steering pump


How much transmission fluid does a 1999 Oldsmobile silhouette hold?

8 quarts


How much motor oil does a 1999 Oldsmobile silhouette takes?

4.5 Quarts of oil.


How do you diagnose a pulley or shaft misalignment on a 1999 Oldsmobile Silhouette?

Use a straight edge.


Where is the Water Pump located on a 1999 Oldsmobile silhouette?

The water pump on a 1999 Oldsmobile Silhouette is located at the front of the engine, mounted on the engine block. To access it, you typically need to remove the serpentine belt and possibly other components like the engine cover. It is situated near the timing cover and is connected to the coolant hoses. Always consult a repair manual for specific instructions on accessing and replacing it.


How install head gasket to Oldsmobile silhouette 1999?

To install a head gasket on a 1999 Oldsmobile Silhouette, first, ensure the engine is cool and disconnect the battery. Remove the intake manifold, exhaust manifold, and any components obstructing access to the cylinder head. Clean the surfaces thoroughly, place the new gasket into position, and then carefully align and reinstall the cylinder head. Finally, torque the head bolts to the manufacturer's specifications in the correct sequence before reassembling the remaining components.


Where do you fill reservoir for back windshield on Oldsmobile silhouette 1999?

It is under the hood next to the engine.


What is the engine for a Oldsmobile silhouette?

that would depend on the year, but my 1999 (and newer models) have a 3.4L v6