answersLogoWhite

0

What else can I help you with?

Related Questions

Is bank 1 o2 sensor in a 2002 Chrysler Sebring in back of engine?

Yes.


How many O2 sensor in 2002 Chrysler Town and Country?

A 2002 Chrysler Town and Country has two oxygen sensors.


Which o2 sensor is bank 1 on a 1997 chrysler LHS?

Passenger side is bank one on a LHS.


What is the part number for an O2 sensor bank 1 sensor 1 in an 2002 Mitsubishi Galant 4-cylinder?

Mitsubishi Galant, 2002, 4-cyl, O2 sensor, bank 1 sensor 1 (upstream)... PART NUMBER: MR506364


2002 Dodge Intrepid o2 sensor bank 1?

Bank 1 is the pass side.


Where is the O2 sensor bank 2 located on a 2002 town and country?

There is no bank two on this van.


What is Chrysler check engine code P0135?

This is a generic O2 Sensor code, usually used on right bank


Error code p0141 Chrysler town and country?

* P0141 02 Sensor Heater Circuit Malfunction (Bank 1 Sensor 2) The after catalyst O2 sensor has failed.


What oxygen sensor should you get for a malfunction code PO155 for a 2002 Mitsubishi Montero Limited and where is the sensor located for repair?

P0155 = O2 sensor heater circuit malfunction (Bank 2 Sensor 1). All O2 sensors are threaded into the exhaust system at various points. Bank 2 would be the bank of cylinders that does not contain the #1 cylinder. Bank 2 Sensor 1 would be the first O2 sensor leading from bank 2 of the engine.


Is the bank 1 sensor 1 o2 sensor on a 97 Chrysler lhs upstream or down stream?

Bank one is the same side as cylinder number one. Sensor one is upstream or before the catalytic converter.


Where is O2 sensor bank 1 located on a 2002 chrysler town and country?

Bank 1 sensor 1 is screwed into the exhaust manifold on the back of the engine. Bank 1 sensor 2 is screwed into the catalytic converter.Bank 1 sensor 1 is screwed into the exhaust manifold on the back of the engine. Bank 1 sensor 2 is screwed into the catalytic converter.


What is po137 02 sensor circuit low voltage bank 1 sensor 2 on 2002 Venture?

Bank 1 Sensor 2 is the sensor AFTER the catalytic converter. Causes could be,A faulty O2 sensor, Exhaust leak near the sensor, Damaged catalytic converter, Damaged wiring to O2 sensor,