where is the ac condenser drain tube on a 2008 Saturn Outlook.
on the ac condenser
There is no drain on an AC condenser it is a closed pressurised system. To drain it you have to hook up a machine that sucks the freon out.
The A/C condenser drain is located underneath the car toward the center of the vehicle. Just follow the outline of the condenser box, it should have a rubber nipple on it.
The ac condensation drain is located at the bottom center of the firewall, directly above the transmission on the 2008 Toyota Tundra (5.7 Force 6-spd automatic). It is not a tube but a 2-inch (approx) grommet-type opening that deposits the condensation onto the top of the transmission.
The drain for the condenser may be clogged.
The 1997 VW Jetta air conditioning condenser drain hose can be found on the bottom of the air conditioner compressor. The drain hose will direct condensation to the bottom of the engine compartment.
in the front passenger side of the motor
To remove the AC condenser on an XK8 Jaguar, first, ensure the vehicle is off and the battery is disconnected. Then, drain the refrigerant from the AC system by taking it to a licensed technician. Next, remove the front grille and radiator to access the condenser; disconnect the refrigerant lines and electrical connectors. Finally, unbolt the condenser from its mounts and carefully remove it from the vehicle.
The ac condensation drain is located at the bottom center of the firewall, directly above the transmission on the 2008 Toyota Tundra (5.7 Force 6-spd automatic). It is not a tube but a 2-inch (approx) grommet-type opening that deposits the condensation onto the top of the transmission.
If it's not related to outside weather, then check the drain for your AC condenser.
To replace the AC condenser on a 2008 Hyundai Santa Fe, first, disconnect the battery and recover the refrigerant using a recovery machine. Next, remove the front grille and any necessary components like the radiator and fan assembly to access the condenser. Disconnect the refrigerant lines and mounting bolts, then remove the old condenser. Install the new condenser by reversing the steps, ensuring to replace any O-rings and recharge the AC system with refrigerant.
To drain the compressor you have to remove the compressor from where it is mounted and physically drain the oil from it. From the lines, condenser and evaporator you have to isolate each item and use a flush kit available at your local auto parts store. It is nearly impossible to completely remove all the oil and trash from the evaporator and the condenser.