On a 1998 BMW 528i, the O2 (oxygen) sensors are located in two places: one is upstream (pre-catalytic converter) and the other is downstream (post-catalytic converter). The upstream sensor is typically found in the exhaust manifold or just before the catalytic converter, while the downstream sensor is located after the catalytic converter in the exhaust system. To access them, you may need to lift the vehicle and work from underneath or remove some engine covers. Always ensure the engine is cool before attempting any maintenance.
It depends on what options the 98 and 97 have. If you get the vin # on both cars and call BMW they can tell you for sure if it will fit.
The transmission dipstick in a 98 BMW 528i is on the driver's side of the transmission pan. Make sure you are parked in a level spot before you check it.
I know this is not your question, but I bought a 2000 528i with 68K miles in almost perfect condition. So with a 1998 I really would not but anything with more than 90K miles...
On a 1998 BMW 528i, the brake fluid reservoir is located on the driver's side of the engine bay, near the back of the engine compartment. It is typically a translucent plastic container with a cap labeled for brake fluid. To check or add brake fluid, make sure the engine is off and allow the engine to cool down before opening the reservoir.
The speed sensor on a 98 Jetta is located near the brake setup. It is on the passenger wheel area mounted to a bracket.
The knock sensor is located on the 95 oldsmobile 98 with a 3800 engine under the midpoint of the heads.
sensor is located on coolant housing at engine front
No such sensor.
The Speed Sensor Is Located on the transmission. On The Top Towards the Back
on top of the transmission
Is it located near the oil filter
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.