answersLogoWhite

0

On a 2009 Chevy HHR, the crankshaft position sensor is located near the bottom of the engine, typically on the engine block, near the crankshaft pulley. It is usually positioned on the driver’s side, close to the transmission bell housing. You may need to remove some components for easier access, so it's advisable to consult a service manual for specific details and diagrams.

User Avatar

AnswerBot

1mo ago

What else can I help you with?

Related Questions

Where is the IAT sensor located on a 2009 Chevy silverado 5.3 engine?

It's located with the MAF sensor on top of the air intake just after the air filter box.


Where is the ambient temperature sensor on the 2009 Chevy Malibu?

The ambient temperature sensor on the 2009 Chevy Malibu is typically located in the front of the vehicle, near the front grille or bumper area. It is often mounted on the passenger side, behind the grille, where it can accurately measure outside air temperature. This sensor provides data to the vehicle's climate control system and dashboard display.


What actors and actresses appeared in Positioning - 2009?

The cast of Positioning - 2009 includes: Caroline Olea as Mary Pontus Olgrim as Andrew


Where is internal cam positioning sensor on a 2009 Ford Escape?

The internal cam positioning sensor on a 2009 Ford Escape is located within the engine's timing cover, specifically near the camshaft. To access it, you typically need to remove the engine cover and possibly other components to reach the timing chain or belt area. It’s advisable to consult a repair manual or a professional mechanic for detailed instructions, as the process may vary based on the engine type.


How do you reset the tire pressure light on a 2009 Chevy hhr?

It will reset itself while driving if pressure in spec and sensor itself is not bad


What color wire is the signal wire for the 2009 Chevy aveo O2 sensor?

In the 2009 Chevy Aveo, the signal wire for the O2 sensor is typically the white wire. However, it's important to verify this with a reliable repair manual or wiring diagram specific to your vehicle, as wiring color codes may vary. Always exercise caution when working with automotive electrical systems.


Where there any recalls in 2009 for Chevy trucks?

There was only one incident in 2009 where there was a Chevy truck recall. It was the Chevy Silverado.


How do you replace 2009 Chevy aveo throttle position sensor?

To replace the throttle position sensor (TPS) on a 2009 Chevy Aveo, first disconnect the negative battery cable to ensure safety. Locate the TPS on the throttle body, remove the electrical connector, and unscrew the sensor from its mounting. Install the new TPS by securing it in place, reattaching the electrical connector, and finally reconnecting the battery cable. Be sure to check for any error codes and perform a throttle relearn procedure if necessary.


Where is the oxygen sensor bank 2 sensor1 located on a Chevy Traverse 2009?

On a 2009 Chevy Traverse, the oxygen sensor bank 2 sensor 1 is located on the exhaust system, specifically on the exhaust manifold or just downstream of it on the exhaust pipe. Bank 2 refers to the side of the engine that is opposite to bank 1, which is typically the side with the cylinder 1. To access it, you may need to lift the vehicle and work from underneath or remove some engine covers or components for better access.


Where is the coolant temperature sensor on a 2009 Chevy aveo located?

the temp sensor is located on the right side of the engine under the intake manifold on the engine block. Easiest access is from underneath. Location on engine: no special tools is need it to remove it


What is Chevy's fastest car?

2009 Chevy corvette


Did they make a 2009 Chevy Trailblazer SS?

Yes, they made a 2009 model of the Chevy Trailblazer SS.