I dont think their is one (crankshafts usually sit in oil-they are extremely heavy metal and rotate very fast...your rpms measure how many times the crank makes a 360degree rotation in a single minute.....)but Lucky for us.......A crankshaft does not need a sensor....if you have failure, your engine wont start.
Oh yeah, the 4-stroke cycle is completed when the crank spins a full 720degrees-180per stroke. I dont think their is one (crankshafts usually sit in oil-they are extremely heavy metal and rotate very fast...your rpms measure how many times the crank makes a 360degree rotation in a single minute.....)but Lucky for us.......A crankshaft does not need a sensor....if you have failure, your engine wont start.
Oh yeah, the 4-stroke cycle is completed when the crank spins a full 720degrees-180per stroke.
i have an 03 sonata v6 base model... maybe the GLS does but the base doesn't.... i just rely on the squeelers on the brake pads..
It is located inside the timing cover on the right side of the crankgear
CJ GLS was created on 1998-03-02.
Winter Sonata ended on 2002-03-19.
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
in the engine block at the botton
Mr ben
It is up under the starter motor.
Something must have been installed improperly when installing the crankshaft. Have a professional look at your vehicle to double check the installation.
Phone a Vauxhall dealer, quote the vehicles registration or chassis number, and ask.
Trouble code P1345 means: Camshaft To Crankshaft Position Correlation Fault
It is a pain to get out! a stud prevents yopu from getting a socket on the bolt for the sensor!