0
What else can I help you with?
How do you take off crank shaft pulley on a 1995 Honda passport?
disconnect the battery, remove the bolt in the center of the pulley, then use a harmonic balancer tool to remove it
How can you tell if the crank shaft pulley is broke in a 2000 Dodge Intrepid 2.7 liter 6v engine?
Take It Off Amd Inspect It.
How do you remove the crank shaft pulley on a Grand Am SE?
its located on the front passenger side of the car.first take off the tire,then the inner fender and the crankshaft pulley will be right there. its also easier to do with air tools.
How do you change a harmonic balancer on a 2001 impala?
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
How do you change 1993 Corvette crank pulley?
take off the belt, use a pulley puller to pull it then reinstall.
How do you remove a harmonic balancer on a 99 Chevy Monte Carlo?
take off the serpentine belt and crank pulley and you will need a harmonic balancer pulley to get it off.
How do you remove crank pulley 92 lumina van with 3.8?
I want to take off the pulley wheel off,from a 1992 chevy lumina apv van.
Where is crank position sensor on 2003 aztek?
usually behind the crank pulley, if you take the passenger side wheel off you will be able to see part of the pulley, very bottom one.
How do you install cps on 97 Honda civic?
You need to take your crank pulley off the plastic cover and your there
97 Dodge Stratus 2.4L I am trying to take the crank shaft pulley off but the frame where the right engine mount rests is blocking it Am I missing something?
u have to take the motor mounts out on the right side it drops it enough to take it off trust me i just replaced my water pump on mine
How do you remove a harmonic balancer on a 2000 impala 3.8?
Take the serpentine belt off and then take the crankshaft pulley off and you will need a puller to get the balancer off the crank.
Where is the crank shaft sensor located on a 1997 Buick Riviera?
it is to the right side of the crank shaft pulley it will have a connector to it held on by two bolts. you have to pull the crank pulley first. use a three hole puller, called a chicken foot, because it looks like a chicken foot. there will be little holes in the face of the pulley. the bolts needed will be 6mm about 4in long. the pulley will come off, remove the plastic piece covering the sensor and replace. do not pry on the pulley, it is easy to bend the teeth behind it, and it must be able to pass through the ridges on the new sensor. make sure it is the crank sensor you need to change before doing all this and not the cam shaft sensor, just above the crank sensor, they will both give the same problem. No spark. good luck.
