0
What else can I help you with?
Where is low pressure ac access fitting for 2002 Chevy pickup?
The LOW pressure fitting is SMALLER than the HIGH pressure fitting.
Where is the Low side to recharge AC in a 1996 lumina van?
The high pressure fitting is located either in the high pressure vapor line or muffler, while the low pressure fitting is located on the accumulator.......
Oil pressure is reading high on corvette but oil is at correct level. Does this indicate a bad sensor switch?
High oil pressure is good....
How do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?
how do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?
Why would the high beams work and the low beams not work on a 1977 corvette?
Bad bulbs?Bad Hi-low switch?
Where is the low pressure line located on a 1997 thunderbird for the purpose of charging the AC unit?
The low pressure filler fitting is the one nearest the dashboard, and the high pressure fitting is the one nearest the radiator. They both have black plastic screw-on caps.
What hoses go to the 2.9 liter powersteering pump?
THERE TWO HOSES, HIGH PRESSURE SIDE AND RETURN. HIGH PRESSURE COMES FROM FRONT FITTING TO SIDE OF POWER PUMP.
Where is high beam switch location on 1977 corvette?
It is on the signal light switch. Pulling it toward you will change from High to Low beam lights and vice-versa 7T77T7
Where is the dimmer switch on 1977 Corvette?
The dimmer switch is located on the turn signal switch. Pull it toward you to switch from low to high or high to low beam lights.
How do you turn on the high beams for 1979 Corvette?
how do you turn on high beams on 1979 corvette
How do you add freon to a 1991 Acura Integra LS?
Same as any other car...attach fill hose fitting to the low pressure side of the system (it won't fit on the high pressure side fitting) and open the fill valve.
Does adding freon go to high or low pressure side?
Always to the low pressure side. The low pressure side fitting is normally near the dryer ( large silver canister).
