Pretty sure it on the side of the distributor's . You'll see the motor craft logo on it . Also you'll need a special tool to take it off .All it is , is a real tiny nut driver. You can pick one up at you local auto parts store real cheap.
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
Is the Claias 2.3L 2.5L or 3300?
The coils are bolted to the ignition control module, there is no coil wire as such.
on the drivers side just under the exhaust manifold
what is the wiring position for the ignition module on a 1990 Buick Park Avenue?
The ignition module for a 1990 Pontiac Trans Sport with a 3.3-liter engine is located on the ignition coil assembly, which is typically found near the front of the engine, close to the intake manifold. To access it, you may need to remove the ignition coil cover. Make sure to disconnect the battery before attempting any repairs to avoid electrical shock or damage.
i replace the erg,tps,idle control module and ignition control module,and while driving past 30mph i loss power why
i know on a wb its in distributor
it's underneath the rotor in the distributor. you have to take the distributor out to change it.
All 1987 to 1990 Chevy Celebrity engines use distributorless ignition. Timing is controlled by the engine control module in conjunction with the ignition module. There is no provision for adjustment.
The ignition module is located in the distributor
the 3.1 liter v6 uses the ignition module as the crankshaft sensor and there is no camshaft sensor because it is multi port injected