On a 1990 Chevy 454SS engine, the knock sensor is typically located on the engine block, near the oil pan. Specifically, it is situated on the driver's side, towards the rear of the engine, usually around the area where the block meets the transmission bell housing. It's a small sensor with a single wire connector. Make sure to consult the vehicle's service manual for exact location and specifications.
It is over by the starter and screewed into the engine block.
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
The 1997 Chevy 1500 pickup truck 5.7 liter engine knock sensor can be found on the front of the engine. You will need to remove the front engine cover in order to access the sensor.
Need to know what engine it has.
The knock sensor is located on top of the block in a 4.8 2002 engine. The intake will have to be removed to get to the sensor.
You have another problem other then the knock sensor if the engine will not start and run. A knock sensor will not cause the engine not to run.
That is the knock sensor
It's a sensor that tells the computer if there is a rod knock in your engine.
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
It is over by the starter, and screewed into the engine block.
That is the knock sensor.