0
What else can I help you with?
Where is a ignition control module a 1987 Chevy blazer s10?
The ignition module is located in the distributor, under the distributor cap.
Will a bad ignition module for a 96 S10 pickup make it stall and what does it do?
Yes, My ignition module was bad, I experienced intermittent stalling. My mechanic replaced and it stopped.
Were is the electronic ignition module at on your 1996 Chevy s10 truck?
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
How do you remove the ignition module chev 4.3 s10?
To remove the ignition module from a Chevy 4.3 V6 engine in an S10, first disconnect the negative battery cable to prevent any electrical shorts. Next, locate the ignition module, which is typically mounted on the distributor. Remove the screws or bolts securing the module to the distributor, then carefully disconnect the electrical connectors. Finally, lift the module away from the distributor to complete the removal.
How do you install a ignition modulator in a 97 Chevy blazer s10?
my ignition module for a 93 s10 was hld by two small bolts on top of the distributor. don't drop one of them into a storm drain they are not easy to buy.
Where can you find a wiring diagram of the ignition system on a 1988 Chevy S10 Blazer?
autozone.com
Where is the ignition control module located on a 1994 s10 pickup?
It is bolted inside the distributor under the rotor on bass plate
How do you install key ingition switch 1988 Chevy S-10?
how do install key ignition switch 1988 Chevy s10
Where is ignition module located on a 1996 Chevy truck?
under the distributor cap. it is black plastic and has 2 small screws in it New answer: Sorry but that year did not use an ignition module. It use a crank senser and cam senser. If this is a S10 with the 4.3 L engine, it has an ignition module and it is attached to the bracket that also holds the ignition coil on the passenger side of the engine.
Location of the oil pump on a 1988 S10 blazer?
Inside of oil pan.
What is the ignition timing on a 1988 Chevrolet S10 Blazer 2 8 liter engine?
10 degrees
Where is the ignition control module on an 1994 s10 pickup located?
Remove the distributor cap and it will be bolted inside the distributor on the base plate.
