There is no OBD-2 on that model... They first OBD 2 Wrangler was the 1997 model. The 1995 connector is under the hood.
The low pressure port comes out of the aluminum pipe close to the ac drier. The low and high pressure ports have different size fittings, so there is no chance of connecting to the wrong port.
The 2002 Jeep Wrangler OBD 2 port is below instrument panel, left of brake pedal
To charge the AC on a 1998 Jeep Wrangler, first locate the low-pressure service port, which is typically found near the accumulator on the passenger side. Ensure the AC is set to the maximum cool setting and the engine is running. Attach the AC recharge kit to the low-pressure port, following the instructions on the canister, and gradually add refrigerant while monitoring the pressure gauge. Once the desired pressure is reached, disconnect the kit and check for proper AC operation.
It is under the dash on the driver side.
The 1993 Jeep Wrangler as are all modern vehicles is equipped with the on board diagnostic system and access port. The OBD Series I connector port will be located on the right front side of the vehicle below the steering wheel.
The 1988 Jeep Cherokee air conditioning low pressure port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.
A 1995 Jeep uses R134a, not R12. The caps are grey or black.
The 1995 Audi low pressure port can be found on top of the air conditioner compressor. You can recharge your air conditioning system through the low pressure port.
low pressure port is on top of the ac compressor
Low pressure port.