answersLogoWhite

0

What else can I help you with?

Related Questions

Where is fuel sending unit on 1994 Mazda b4000 truck?

where i look only year 1994 mazda b4000 truck -fuel sending that find hard time


Where is the oil sending unit on 2000 Mazda B4000?

I believe it is on the drivers side of the engine , below the power steering pump


Where is the sending unit on a 1998 Chevrolet Tracker?

DID U HAVE ANY ParTICULAR SENDING UNIT IN MIND ???


How do you replace fuel sending unit on 1998 Chevy S10?

The fuel tank has to be removed to gain access to the fuel sending unit. The fuel sending unit and the fuel pump is replaced as a unit.


Where is oil pressure sending unit for 1998 Mitsubishi mirage?

Were is the oil pressure sending unit on a 95 mitsubishi miaage


Where is the oil pressure sending unit on a 98 Honda accord?

The oil sending unit is below the thermast housing on a 1998 accord


Where is the 1998 olds fuel sending unit?

in the gas tank


Where is the temperature sending unit on a 2001 Mazda Milenia?

Temp sending units in general (not always) are usually found close to the thermostat.


How much work is it to repair a broken gas tank strap and replace the sending unit on a 1994 Mazda B4000 5-speed rwd manual V6?

It is easier to handle the tank with no gas as gas weighs about 7-1/2 pounds per gallon. Take the tank off and then the strap just connects to the frame and then remove the tank unit.


Where is the water temperature sensor located on a Mazda B4000 truck?

There are two engine coolant temperature sensors. One drives the gauge or warning light on the instrument panel generally referred to as the sending unit. The other is used by the computer to determine engine coolant temperature and adjust the fuel/air mixture accordingly; this is generally referred to as the sensor. The two are easily distinguished, since the sending unit for the temperature guage has only one wire going to it, while the unit that provides information to the computer has two or three wires to it. On V6 engines, the sending unit for the gauge is located on the front lower part of the intake manifold, near the thermostat housing. - Mazda Pickups Service Manual


What would the problem be on a 2006 Mazda mpv minivan with a fuel gauge that doesnt work?

A bad fuel sending unit, a fault in the circuitry for the fuel sending unit, or possibly a faulty gauge.


Where is oil pressure sending unit on Mazda 626?

if its the 4 cly its right above the oil filter