0
What else can I help you with?
3.8L stalls at idle warm Tach goes to zero then stalls?
Most likely the ignition module.
How do you test the Ignition control module for a Nissan 300zx?
If you can start the engine when cold, but it sputters and stalls when it's warm, then you most likely have a bad ICM. When you crank the engine, if you have tachometer movement, then the module is good, if there's no tach movement while cranking then the module is bad. The tachometer gets the signal from the module, so if the tach works, then the module is good.
What might be wrong with a 1996 Honda Civic DX that suddenly stopped running?
ignition module It's possible that the CDI module went bad. If the car has a tachometer built in to the dash you can use that to make a simple check. Crank the engine while watching the tach. Does the needle on the tach bounce slightly when cranking or does it stay still? If the tach needle doesn't move the CDI module is dead. If the tach needle does move the problem is somewhere else.
How do you install a hood tach on1967-69 Pontiac GTO?
To install a hood tach on a 1967-69 Pontiac GTO, start by removing the hood to access the mounting area. Position the tachometer at the desired location, usually centered on the hood, and mark the drill holes. Drill the holes carefully, then secure the tachometer using the provided hardware. Finally, connect the tach's wiring to the ignition system, ensuring a proper ground and power connection. Reattach the hood once installation is complete.
Where is the tach wire at the coil pack on a 1994 Pontiac Bonneville?
On a 1994 Pontiac Bonneville, the tach wire at the coil pack is typically found near the ignition coil's connector. It is usually a gray wire that connects to the negative terminal of the ignition coil. This wire sends a signal to the tachometer to indicate engine RPM. Always consult the vehicle's service manual for precise wiring diagrams and specifications.
How do you wire up a factory tach in a 1986 Pontiac Grand Prix?
The tach should connect to the distributor.
How do you hook up a Sunpro tach to an MSD ignition?
There should be a tach output connection on the side of the box somewhere, you just plug your tach pickup into that. If it doesn't work you'll need a MSD tach adapter. I'm unsure of the part numbers but there are 2 different ones, it depends on what you used to wire in your ignition. If you used the white wire there is one and if you used a magnetic pickup ( green and violet wires ) there is another one....MSD-8920. I have a sunpro tach and I had to go out and buy an adapter to make it work...for about 50 bucks.
Does anybody know with a 96 s10 pickup that has no tach from the factory can you install a cluster that has a tach Will the connection be there for a tach if originally it did not have one?
theirs a green wire by distributer that is for the tach
How do you install an aftermarket tach on a 2002 Pontiac Sunfire?
You need an aftermarket tach adaptor autometer makes a good one
How do you hook up a tach to a 1984 Chevy 350 engine?
if it is a hei ignition there is a place on the distributor cap that says tach.
Why is my Tach not working on my 1986 Camaro after removing the ignition coil and reinstalling it?
There is a wire next to the large (red) battery wire that is for the tachometer. Check to see if you plugged it back in and is the connection good.
A wiring diagram for 1968 Pontiac Firebird hood tach?
I need the pinout for a 1968 Pontiac Firebird hood tachometer. Specifically, the tach side connector. I have three wires coming from the engine side and seven off the tach. One broke off and can't immediately see where it was. Help?
