It is located on the drivers side right above the exhaust manifold towards the front/next too the first exhaust port
where are the temperature sending unit located on a 1990 Chevy engine 5.7
Below the water neck on the front of the intake.
fords don't have a 350 the 350 is a Chevy motor
I will doubt the connection or the sending unit. Hope this will help.
At the back of the block, near the distributor.
It is right behind the distributor. It is HARD to see and to get to.
Back of the engine, on the top next to the distributor.
It is hard to see and to get to. But it's right behind the distributor.
. Route from inside vehicle without crimping or cutting thermal tubing then remove temoperature sending unit from engine and replace with Sun bulb assembly
It is screewed into the top of the block right behind the distributor. It is HARD to get to.
In back of the engine, on top, drivers side, next to the distributor.
Screw out the oil sending unit. Put a "tee" back into the hole. Screw in the oil sending unit for the light AND the fitting for the mechanical oil gauge.