0
What else can I help you with?
What is the horsepower rating on a Gm 366 motor?
The GM 366 motor has a horse power of 300 at 4,400 RPM. The 366 engine is an?æeight cylinder with 6-liter engine.?æ
Where is the thermostat located on a gm 5.7 liter engine?
Should be in a removable housing at the engine end of the upper radiator hose
Where is the thermostat located on a 2001 Buick Century?
The Thermostat is located in the neck where the upper radiator hose connects to the engine. you have to take off the upper intake plenum to access this. Alot of crap just to change the thermostat. excellent design GM. Jamie
Where is the thermostat on 1988 454 gm?
At the engine end of the top radaitor hose, under the thermostat housing.
How much horsepower does a 366 cid gm have?
There are several horsepower options for 366 cubic inch General Motors engine. The largest General Motors horsepower option was 420 horsepower.
What was the last year gm used a carburetor on a 366 cu in?
General Motors last used a carburetor on the 366 cubic inch engine in 1995. After that, the engine transitioned to fuel injection systems, which became the standard for improved efficiency and performance. The 366 engine was primarily used in commercial applications, such as trucks and buses, during its production run.
Where is the timing bypass wire on a 1993 GM top kick with a 366 engine?
On a 1993 GM Topkick with a 366 engine, the timing bypass wire is typically located near the distributor. It's usually a single wire that can be found in the engine compartment, often near the ignition module or on the harness leading to the distributor. To enable the timing bypass for setting the ignition timing, you would need to connect this wire to ground. Always refer to the vehicle's service manual for specific details related to your model.
Where is the camshaft sensor located in a 1996 gm 4.3 engine located?
Its in the distributer.
Where is the starter located on a gm 3.4 engine?
The starter is located on the right hand side of your GM 3.4 liter engine. You can follow the positive battery cable directly to the starter.
What side the 1 cylinder is located?
On a GM engine The #1 cylinder is located drivers side, front of engine.
How many cubic inches in a 6.0 liter GM engine?
The same that's in a Ford 6.0 liter engine. That's a stupid answer to a valid question. The true answer is 366 cubic inches. Thank you.
Where is the voltage regulator located on a 1990 Gm K1500 with 5.7L engine?
On GM vehicles it is inside the alternator and is not serviceable.
