0
What else can I help you with?
Where is modulator valve on 1986 turbo 350 trans?
on thepass side of the transmission pan.it has a hose connected to it.
Where is the modulator valve located on A 1988 MAZDA 626?
It is on the transmission. It has a vacuum hose connected to it. It is round, about two inches in diameter. Robert Foley.
Where do you attach a vacuum hose to the modulator valve on the transmission of a 305 Chevy?
If your transmission has a modulator it is on the side of the trans and it has a nipple on it for the vaccum line. I you. Mark
Does the 1994 s10 blazer havve a modulator valve?
assuming your talking about the transmission modulator...visually inspect the transmission and look for a vacuum hose from the engine to the tranny...
Where does the vacuum modulator hose connect to besides the transmission on an 96 Astro Van?
In a 1996 Astro Van, the vacuum modulator hose connects to the intake manifold in addition to the transmission. This connection allows the modulator to receive vacuum signals that help regulate transmission shifting based on engine load and performance. Make sure to check for any potential leaks in the hose, as they can affect transmission operation.
Where do the modulator valve and transmission solenoid go in a Lumina van's transmission?
The modulator is located just above the starter on the side of the transmission, it has a vacuum hose attached to it. The solenoid is located in the transmission, you have to remove the transmission pan to remove it.
How do you remove the modulator on a Ford Aerostar transmission?
The modulator is held into the transmission with a stamped metal "fork" that is bolted into the transmission. Remove the bolt, remove the vaccum hose and wiggle/turn the modulator to extract it. Be careful during the removal because there is a short pin in the modulator that has to be replaced when you put the new one in. .
Where is the vacuum modulator on a 1979 Chevrolet pickup?
Are you asking about the vacume modulator for the distributor? That is on the distribiter, you will see a hose on it or wher hose should be. If ou are wanting vacume modulator for the automatic transmition it should be on passenger side of transmission toward the back.
How do you change transmission modulator valve in a 97 Pontiac Bonneville?
To change the transmission modulator valve in a 97 Pontiac Bonneville you will first need to lift the vehicle off the ground. Then, remove the vacuum hose and the defective valve. You can then replace with new, and replace the hose.
How do you adjust a vacuum modulator?
I assume your refering to the vacuum modulator which controls transmission shift points. Remove the vacuum hose from the modulator. Using a small screwdriver, turn the screw inside the modulator. It may take several tries to get it right.
Where does the vacuum hose originate from that goes to the modulator on the transmission?
It's a constant source such as the intake manifold or the base of the carburetor.
Where is the transmission vacuum modulator 1986 Chevy Suburban?
It is on the passenger side of the transmission towards the back of it. It will have a vacuum hose hooked to it. There will be a small bracket with 1 bolt that holds it in the transmission. Do not loose the small pin that is inside of the transmission when you remove the modulator valve. You will loose some trans. fluid.
