answersLogoWhite

0

What else can I help you with?

Related Questions

Can you use bismuth shells in a full choke shotgun?

You can not use. Or should not use. The wad stays with shot exiting. I suggest improved cylinder or bore


What is a Mossberg 500 Cylinder bore barrel?

"Cylinder bore" means the bore diameter at the muzzle is the same size as the bore at the front of the cylinder where the shell is when it's fired. Shotguns use "choke" settings to restrict the size of the mass of lead pellets coming out of the muzzle to tighten the mass down onto a further target....a cylinder bore gun has zero choke restriction so the mass of lead pellets stays wide and spread out. Cylinder bore guns are meant strictly for close in targets for that reason.


When purchasing new head gaskets do you want the same bore on the gaskets as the actual cylinder bore?

No, the head gasket bore size refers to the diameter of the bore and should be larger than the cylinder bore. If the engine cylinder has been chamfered at the top of the block, to make it easier to start ring assembly, the the gasket bore size should be at least that diameter. As an example, on a chevy small block with a stock 4 inch bore, the next gasket size is typically 4.030". Engines that have been bored out up to 4.040" will use a gasket size of 4.060". If you use a gasket smaller than the bore size, the gasket will fail as it can create hot spots that will cause pre-ignition. If the gasket bore size is too large it will create a cavity area that prevent a clean burn in the combustion chamber thus creating dirty emissions.


How can you find the bore diameter of the cylinder?

Use a caliper that's made for inside measurement.


Can i use a head gasket I bought for a 2.5L 4 cylinder be used on a 3.5L?

No - the bore for the cylinders are different


How are bore and stroke given in the metric system?

Bore and stroke are typically given in millimeters in the metric system. Bore refers to the diameter of the cylinder, while stroke refers to the distance the piston moves from top dead center to bottom dead center in the cylinder.


Which choke is best when hunting ducks?

Improved cylinder or larger. Actually alot of folks do very well with a skeet gun.


Where to use reduced bore and full bore?

Use full bore for applications where pressure drop should be minimum (such as in the suction pipe of a pump with required NPSH very close to available NPSH), or for pipes which could be cleaned with a pig (so that the pig doesn't get stuck on the valve). In other applications a reduced bore should be OK.


How do you calculate which size cylinder bore is required for a hydraulic power pack?

First you need to know what force is required. The pressure the cylinder is going to work at. From this you can wok out the area of the piston and then the diameter of the piston. Force = Pressure x Area


How engine capacity is worked out 4 cylinder engine?

I assume you mean engine displacement? To calculate engine displacement, use this formula: Bore x bore x stroke x .7854 x number of cylinders.


How do you clean a Rohm 38 RG63 handgun?

Open the cylinder, remove all ammunition, check it again. Use a cleaning rod with a patch holder tip to swab the bore, chambers, and inside of the frame with patch wet with powder solvent. Replace patch holder tip with bore brush, and use brush to scrub bore and chambers. Use patch holder tip to run clean patches through the bore and chambers. Use a clean patch to wipe inside of frame.


Use the word bore in a sentence?

And bore the insignia of duke university