Check engine is on BECAUSE the speedo is inop, assuming it was not on prior to speedo malfunction. Speedo is electronic. Could be numerous reasons ( no fuses are involved). Could be something simple like an electrical disconnect at transmission. Good luck
On the gearbox.....
you have either a bad speed sensor (check engine light on?) or a short in the printed panel and amp/ voltage reg. on the back of the speedo head. no check engine light on replace/ rebuild speedo head there are speedo shops. if light is on replace speed sensor as the OBD system uses this sensor to. clear codes and happy driving Johnie
on the bike somewhere
There is no speedo cable on a 96, GM quit using them in 1987. You have a speed sensor, which is located on the top rear of the transmission. It will have a couple wires coming off it in a plug, that run thru the computer, then to the speedo. If your speedo has quit working, has it also set a check engine light? If so, I would recomend replacing the speedo sensor.
Fiero does not use a speedo cable There is an electronic sensor mounted on top of the transmission that both the engine computer and the speedo in the dash read to get the speed.
Yes. Engine, Trans, and ABS have an affect on the speedo reading.
the middle wire on the speedo block on the engine by the gear lever in the engine
Fiero does not use a speedo cable There is an electronic sensor mounted on top of the transmission that both the engine computer and the speedo in the dash read to get the speed.
Fiero does not use a speedo cable There is an electronic sensor mounted on top of the transmission that both the engine computer and the speedo in the dash read to get the speed.
You may have a bad ground
no it does not , remove speedo and dash ,remove tanks , and go to town .