If your Chevrolet Nova continues to buzz after the key is removed from the ignition, it may indicate a problem with the ignition switch or a malfunctioning relay. This buzzing can also be a sign that an accessory or warning system, such as the fuel pump or alarm, is still active. Additionally, an electrical short or a stuck relay could cause the buzzing sound to persist. It's best to have the vehicle inspected by a qualified mechanic to diagnose and resolve the issue.
A 1977 Nova should have electronic ignition and therefore wouldn't have points
A 1977 Nova should have electronic ignition and therefore wouldn't have points
whats wrong with it?
here is a diagram
It was called (and still is) Nova Scotia.
To wire a 1964 Nova ignition switch, first disconnect the battery to ensure safety. Connect the battery power wire (usually a thick red wire) to the "B" terminal on the switch. Then, connect the "I" terminal to the ignition coil, and the "S" terminal to the starter solenoid. Finally, ensure all connections are secure and reconnect the battery to test the ignition.
No, door locks & trunk-one key; Ignition- different key; I know-I have one
BAD IGN SWITCH
To change the ignition key cylinder on a 1976 Chevy Nova, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition switch assembly. Use a suitable tool to release the retaining clip and pull out the old ignition cylinder. Finally, insert the new cylinder, reassemble the column cover, and reconnect the battery.
you need the key to get it out unless you a car thief.
In 74 Chevy went to the HEI system. Prior to that just points.
To change the ignition switch in a 1977 Chevy Nova, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing the screws, then detach the wiring harness connected to the old ignition switch. Unscrew the ignition switch from its mounting and replace it with the new switch, reconnect the wiring harness, and reassemble the steering column cover. Finally, reconnect the battery and test the new ignition switch to ensure it functions properly.