The seat belt is used to complete a circuit to tell your car that you are safely belted in. so some part of that system has come loose. Which is not allowing your car to know you are buckled in.
bong, call, chime, clang, knell, peal, signal, sound,
There is no actual "chime" for the backup warning. The chime is generated by the radio just like the "KEY IN IGNITION" or the "HEADLAMPS ON" chime. The Rear Parking Assist Moudle sends a signal to the BCM which requests the proper chime for the Radio to produce in the speaker(s).
The warning chime is on the instrument cluster. It needs to be disassembled to get to, and it cannot be disabled because it is tied in to the instrument cluster.
plug the seatbelt in.. the warning stops then ;-)
it is an xylophone
Where is the key in the ignition warning chime module located on a 1990 Ford ThunderbirdRead more: Where_is_the_headlight_warning_chime_module_located_on_a_1990_Ford_Ranger_2.9
Could it be any of these; Safety belt warning chimeChimes to remind you to fasten your safety belts. For information on the safety belt warning chime, refer to the Seatingand safety restraints chapter. Supplemental restraint system (SRS) warning chime For information on the SRS warning chime, refer to the Seating and safety restraintschapter. Key-in-ignition warning chime Sounds when the key is left in the ignition in the OFF/LOCK or ACC position and the driver's door is opened. Headlamps on warning chime Sounds when the headlamps or parking lamps are on, the ignition is off (and the key is not in the ignition) and the driver's door is opened.
Pull the key out just a little and the chime will stop. It may be controlledfrom the radio
You can disable the seatbelt warning chime, in your Honda CRV, by removing the fuse. The fuse can be found in the fuse box in the engine compartment.
A wind chime makes its music when the chime is rattled by wind or another force, and the hanging tubes that make up the chime collide. They cause each other to vibrate, producing a resonating "ringing" sound.
The chime is located on the dashboard of the Century. If it does not sound, you may need to have your vehicle's electrical system examined.
A doorbell produces a ringing sound by using an electromagnet that creates a magnetic field when the button is pressed, attracting a metal rod to strike a chime or bell. This action creates vibrations in the bell, producing the ringing sound that we hear.