answersLogoWhite

0

What else can I help you with?

Related Questions

Location of factory key pad code in vehicle?

You mean to get a new key cut ? You need to take a key barrel out and it is on the key barrels, I find the trunk lid key barrel is the easiest to take out.


The ignition will not turn?

Worn key or barrel, do you have a new key you can try it with ? If it still doesn't turn properly you got a worn ignition barrel that has to be replaced


How to get new keys to a Jeep Grand Cherokee Laredo 2001?

Get the key number from a key barrel and order new ones through the maker.


Do you need to reprogramme the immobilizer if you change the key barrel?

Yes, if you change the key barrel in a vehicle, you may need to reprogram the immobilizer system to ensure that the new key works properly. This is because the immobilizer is typically linked to the original key's transponder, which communicates with the vehicle's security system. If the new key barrel does not match the existing system, the vehicle may not start until the immobilizer is reprogrammed to recognize the new key. Always consult the vehicle’s manual or a professional locksmith for specific instructions.


Why does the car not start when only the ingnition barrel has been changed to your corsa c?

The key needs to be coded to the new barrel, or swap the immobalizer ring from the old barrel to the new one(if using the old keys)


How do you put in a new ignition switch on a 1973 Honda 125?

If you have a replacement ignition switch for the same bike. You take the retaining nut off the end of the key barrel and slide it out and you unplug it, then you plug in the new one and put the new key barrel back in and tighten the nut.


How do you remove a barrel lock?

with a barrel lock key


How do you reprogram the key to work the infra red receiver on a Peugeot 405?

If it is the same as the 306, which I would of thought likely, off the top of my head you get your spare key and set it to 'a' position in the ignition barrel. The new remote key you then point at the infra red receiver and hold the button down for 5-10 seconds. Hopefully then if you remove the spare key, the remote locking should then work.


Does changing handles to my car mean i have to change my keys?

no, usually the key barrel can be fitted to the new handles


How do you remove door key barrel on a transit?

To remove the door key barrel on a Ford Transit, first, ensure the door is unlocked. Then, remove the door panel to access the locking mechanism. Locate the retaining clip or screw holding the key barrel in place, remove it, and gently pull the key barrel out of the door. Reassemble the door panel once the key barrel is replaced.


How do you change ignition barrel on 1997 vauxhall vectra?

if you take off the trim around the steering wheel and look at the ign barrel housing at the top of the housing is a very small hole you need a very small screw driver or trim pick that has about one inch of the end bent at a right angle push the end of the pick into the Small hole and press down you will feel a sprung resistance at the end of the pick push down all the way at the same time as turning the key and the barrel will spring out. pull out the barrel and look at the end and see how it is lined up with the key .take the new barrel and insert the key and line it up as the new barrel .slide the new barrel in gently until it clicks. that's it .some times when you remove the old barrel the security lock drops and you cant get the new one in in this case look down the housing and with a screwdriver lift the lock up and the slide the new barrel in .making sure you press the sprung clip in as you do so.


How do you replace ignition key tumbler in 1999 Chevrolet lumina car?

Remove the ignition retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition key tumbler.