The 'click' is probably the sound of the starter solenoid, but if nothing else happens, either the battery is flat, or the starter motor is faulty. -First check battery charge with a meter, charge it if needed. If the battery is good then check the connections at starter, make sure it has a good ground. If still not working , remove the starter and bench test it. -follow procedures in your manual for this.
The most obvious thing to check when a 1991 Oldsmobile Cutlass Supreme won't start is to make sure that the vehicle has gas. You should also check the battery. If the car clicks when you try to start it, it is likely the alternator.
Check the crank sensor
It might be a starter going bad. Had the same problem and was told that it just needed a new starter.
click start> run> then type dxdiag, then press enter, then click on the sound tab.....
Go to Control Panel and double click on "sound". Click the "sounds" tab.
To jumpstart a 1997 Oldsmobile Cutlass Supreme, first ensure both vehicles are turned off. Connect the red jumper cable to the positive terminal of the dead battery, then to the positive terminal of the working battery. Next, attach the black jumper cable to the negative terminal of the working battery, and connect the other end to a metal ground on the dead vehicle, such as an unpainted bolt. Start the working vehicle, let it run for a few minutes, and then attempt to start the Cutlass Supreme.
be more specific what kind of noise if any at all wont turn over ? it will not even crank up
Located in the fuel tank remove to access
Could be in need of a tune up. Start with replacing the spark plugs and spark plug wires.
If you are using Windows, go to start / settings / control panel. Click the sound icon. Click the sound tab and change the "New Mail Notification."
Click the speaker on your start menu bar close to the clock to adjust or mute your Windows sound. Or search in your start menu for sound to enable/disable devices. Also found in the Control Panel.
Go to control panel, double click on Sounds and Audio Devices, then click on the Sounds tab. Scroll down until you find the "Start Windows", click it, click browse, and then select the sound you want as your startup noise, then click ok