A bad turn signal flasher typically won't prevent the brake lights from working, as they operate on separate circuits. The flasher is specifically responsible for the turn signals, while the brake lights have their own switch and wiring. However, if there's a more extensive electrical issue or a shared ground problem, it could potentially affect both systems. It's best to troubleshoot each component individually to identify the exact cause of any malfunction.
Assuming the signal lights still work, no. But a bad brake light switch or a blown brake light fuse could.
Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.
NO brake light come on only when brake is applied the brake light is activated by a switch on brake pedal 2.Turn signal light is activated by your turn siganal lever which control a flasher that make tne light come on and off which is located around steering underdash you will reconize flasher by clicking sound silver small canister good luck
possibly have a brake light out
change the flasher
The signal light flasher on a 1992 Chevy Silverado is under the dash. It is on the driver's side just above the brake pedal.
most likely a bulb b/c if it was the fuse your other brake and signal light wouldn't work... most vehicles the brake and signal light are all in one bulb... try replacing the light bulb
Flasher relay is defective.
The 1995 Mitsubishi flasher relay switch and the brake light relay switch can be found beneath the dashboard. Both switches will be on the drivers side of the dashboard, near the brake pedal.
Check bulbs - double filamented with smaller being for brake light and turn signal Bad switch? Bad turn signal flasher?
More than likely you have a burnt out bulb at the front signal light, rear signal light, or brake light on the right side.
it is either bad signal flasher or bad signal switch assembly try another flasher, swap the hazards one in place of the signals one if the hazards work right now if the hazrds dont work either then it is most likely worn switch assembly(common problem in these cars) i am working on a corsica right now that has no brake lights except the third one and it is the switch assembly worn out in it, flashers are good in it