answersLogoWhite

0

Any cable operated control will stretch from wear over time or if excessive force is used.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Fors Fiesta inside door handle won't open the door what is wrong?

Cable probably snapped


How do you Replace inside front door cable on 1999 Lexus rx300?

To replace the inside front door cable on a 1999 Lexus RX300, first, remove the door panel by unscrewing any visible screws and gently prying off the panel to detach it from the clips. Once the panel is off, locate the cable assembly connected to the door latch mechanism. Disconnect the old cable by detaching it from the latch and replacing it with the new cable, ensuring it is properly secured. Finally, reattach the door panel and test the door operation before securing everything back in place.


What do you do when you can't get the fuel door open on the 2001 VW Beetle?

Place fingernails under outer edge of fuel door. Lift and push door towards the middle of the vehicle. This has always worked for me since the fuel door release stopped working correctly. You can acces the fuel door release cable from the inside of the trunk. Just remove the circular plastic cover inside the trunk nearest to the fuel door, pull the cable until the door releases. To fix this problem permanently you will need to tighten this cable.


How do you replace a drivers side door latch cable on a 2001 Toyota Sequoia?

To replace the driver's side door latch cable on a 2001 Toyota Sequoia, start by removing the interior door panel by unscrewing the fasteners and gently prying it off. Disconnect the old latch cable from the door latch mechanism and the inside handle. Install the new cable by attaching it to the latch and the handle, then reassemble the door panel, ensuring everything is secured properly. Finally, test the door operation to ensure the new cable is functioning correctly.


How do you replace a Toyota sequoia door handle cable?

This is done by removing the trim on the inside of the door. Then it is neccessary to remove the No1 service hole cover. Then one removes the door lock protector, the door handle protector, and detatch the control cable from the outside door handle. You then remove the door lock wire harness loops, and remove the lock from the door. Detach the old cable and reattach the new. and reverse the steps you just followed to reassemble the door.


How do you get the fuel tank door open manually on a 1999 volkswagen beetle?

By the light in the trunk of the car there is a hand sized panel. Inside there is a cable with some foam around it. Pull the cable and the door should pop open.


Sliding on Pontiac trans sport door is stuck how do you get it opened?

if both the inside and outside door handles work then the cable that opens the door automaticlyis jamed in the moter. Replace the auto open moter or like I did cut the cable and use the door manuly.the cable and auto moter is located under the trim on the passenger side in the rear hatch area


How do you replace the mirrors on a 66 Dodge Charger?

I believe they just unbolt from the outside of the door and if remote controlled you will have to take inside door panel off to get the cable out.


Car door wont open from inside?

The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.


How do you adjust fuel door cable on 2000 beetle?

To adjust the fuel door cable on a 2000 Volkswagen Beetle, first, locate the cable beneath the rear seat or inside the trunk area. Inspect the cable for any slack or damage; if it appears loose, you can tighten the adjuster nut on the cable to remove excess play. Make sure the fuel door opens smoothly after adjustment. If the cable is frayed or damaged, consider replacing it for optimal function.


How do you re-attach 1993 E-150 side door latch cable?

To re-attach the side door latch cable on a 1993 E-150, first, ensure the door is open for easy access. Locate the latch mechanism inside the door and identify where the cable connects. Thread the cable through the appropriate guide or slot and securely attach it to the latch mechanism, ensuring it is properly seated. Finally, test the door handle to confirm that the latch operates smoothly before closing the door.


How do you fix the cable inside the drivers door to the power window of a 1997 dodge caravan?

replace window regulator assembly.