answersLogoWhite

0

You cant switch over, it is just a sub-tank that gives you a more accurate reading when your fuel starts getting lower. You cant switch over, it is just a sub-tank that gives you a more accurate reading when your fuel starts getting lower.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

When was Nissan Hardbody Truck created?

Nissan Hardbody Truck was created in 1986.


What is the firing order on 1896 Nissan hardbody?

The firing order of the 1986 Nissan Hardbody is 1, 3, 4, 2. This is the 2.4 Liter 4 cylinder engine.


Fuse panel in Nissan pickup hardbody 1986?

driver side.about 8 inches from floor board.


How do you locate a kill switch for a 1986 Nissan pickup?

no such switch.


What is the gap on the spark plugs of a 1986 and a half Nissan Hardbody?

call the place where you bought your plugs they will know, they usually write the gap setting on the box.


Can a Nissan hardbody bumper fit on my 1990 Nissan pickup?

Yes, even though you do not specify the front or rear bumper, both will fit. All d21 Nissan pickup trucks are referred to as "hardbody". They were manufactured, in the U.S., between 1986 and 1997. Most parts are interchangeable between the years, the only real difference is the bed length between the standard cab and extra cab, they are not interchangeable.


Where is the 1986 Nissan D21 neutral safety switch?

screwed into your transmission.


Kill switch on a 1986 Nissan pickup?

turn key off.


Where is the ignition switch located on a 1986 Nissan 300ZX?

when you start the car up that's your ignition switch is located...


How do you adjust the valves on your 1986 Nissan hardbody z24 motor?

To adjust the valves on a 1986 Nissan Hardbody with a Z24 motor, first, ensure the engine is cold. Remove the valve cover and rotate the engine to set the number one cylinder to top dead center (TDC) on the compression stroke. Use a feeler gauge to check the clearance between the rocker arm and valve stem, adjusting by loosening the lock nut and turning the adjusting screw until the correct clearance is achieved (typically 0.008 inches for intake and 0.010 inches for exhaust). Finally, recheck the clearances and reassemble the valve cover.


Where do the alternator wires go on a 1986 Nissan pickup?

need diagram for 1986 Nissan truck alternator


What does the lights sensor in the dash mean in a Nissan 300zx 1986?

That light indicates that the headlight switch is in the on position with the engine not running and the drivers side door open.