0
Can you replace just 2 scalloped tires or do you have to replace all 4 and can they be aligned if not rotated receiving conflicting advise?
The tires have nothing to do with alignment. The car could be aligned with the scalloped tires. They are scalloped from bad alignment, shocks, struts or damaged to the front end. An alignment in itself may not fix the problem. There may need to be some new parts installed before the alignment. You only need to replace the two scalloped tires. A four wheel alignment can be done with new ones on the front and old ones on the back. Rotating them at some point will not affect the alignment.
What else can I help you with?
What do you do when your car's computer is not receiving the RPMs from your transmission?
check and/or replace the transmission sensor
Why does Jeep shakes at 90km comes out at 100km?
Possibly your wheels need to be aligned or your tires need to be balanced. REPLACE THE STEERING DAMPER
How do you replace a 1996 Geo tracker timing belt on mine there is a 1 with a dot and a 3 with a dot which one should be aligned to the notch?
nothing
What should you do if the 2002 Jeep Liberty sport's AC fan is not receiving power from the fan control?
replace the switch
How do you remove and replace the struts on a 1991 Nissan Maxima SE?
BIG JOB and you need to have the front end aligned before you drive it. TAke it to a garage.
Must a car be realigned after replacing wheel bearings?
Maybe, it depends on what had to be removed to replace the bearings. If the knuckle was removed on a fwd, it may need aligned.
Is it possible to do a front end alignment with worn upper ball joints?
To do so would be a waste of money, replace the upper ball joints first, then have it aligned.
How can I replace a freehub body for my bicycle?
To replace a freehub body on your bicycle, you will need to remove the cassette, axle, and bearings from the hub. Then, unscrew the lockring holding the freehub body in place and replace it with a new one. Reassemble the hub and cassette, making sure everything is properly aligned and tightened.
How do you replace tie rod ends on 1994 Chevy caprice wagon?
Remove the old tie-rod from the knuckle. Loosen (or preferably replace) adjusting sleeve. Put on new tie rod and tighten everything down. Then take it and get it aligned.
You have a 1995 quad 4 grand am Is it difficult to replace the rack and pinion?
I would suggest you take this project to a shop that does alignments also. This sometimes can be alot of work and then it has to be aligned after it is installed.
How do you replace rear wheel bearing in a 1998 VW cabrio?
Take it to someone that does it for a living. Has to be pressed in. It a real pain if you don't have a press It a pain just to get it off, Has to be aligned when put back on
How do you replace the front axle on a 1997 Ford Escort 4-cylinder ABS automatic?
This is a big job and the ft end needs aligned after it is done. Get amanual on your car from the parts store.
