It will cause less damage to trunk by drilling through it with a cobalt drill.
WD 40, or a screwdriver and hammer, but the first one if you have the key
Remove the rear seat and go into the trunk that way use a screwdriver to turn the lock from the inside...
Easy take of the black cover with a hammer, Break out the tail lamp assembly and cut out the lock
Depends on the lock, for instance; to hot wire a car lock you simple take a flat head screwdriver and a hammer. You place the flat head screwdriver in the ignition, hit it with the hammer, and turn the car to start it. Similar methods apply to similar locks ;).
With a Large Hammer
Use a flathead screwdriver and a hammer and break the lock. OUCH!!! well you really stepped in it and that would just spread it around. Go to the back seat, reach under the back section with both hands and a strong/ quick thrust upward will pop the seat back out and up, pull it out of the way and you should be able to reach into the trunk.
drill the lock and push in, lift open the trunk door
The lock has a clip on the inside, pull the clip off and the lock will come out, remove the lock rod and then you can use a screwdriver to open the lock.
Hit it hard with a hammer. Either the lock will break open, usually what happens, or you'll break whatever the lock is on.
Yes
break it open with a hammer or something or pick the lock (if there is one)
You can probably open it with a flat blade screwdriver. The lock itself has a flat blade shaped rod that releases the latch. If the lock is gone, look for a rectangular shaped hole in the latch. Insert the screwdriver and turn clockwise.