0
What else can I help you with?
Why does your dodge ram van vibrates or shakes when the brakes are applied?
you might have a router or caliber gone
03 expedition Replaced front rotors and pads and still shakes when applying brakes?
It must be the rear brakes at fault.
Why does myour car shack when you are stopped?
if you car shakes when its fully stopped it may be the harmonic balancer, take it to a garage. is it shakes only when you are braking while stopping than have you brakes checked
Why Car shakes when stopped on brakes?
You went thru a deep puddle with hot brakes. The disc gets doused in cold water and warps.
Why does car shake when applying brakes?
If the steering wheel shakes, but to car doesn't, when applying brakes - your front rotors are warped (if you have disc brakes)...if you have drum brakes, the drum could be cracked or the pads worn unevenly If the whole car shakes, and the steering wheel only seems to react to that, when applying brakes - see above statement, but apply to the rear end. If the whole car shakes, including the steering wheel - all four corners are bad, and you're an accident looking for a place to happen soon. In any case, go to your nearest service center ASAP.
Your right front wheel shakes when braking at speeds of 50 or higher?
the brake rotors are warped. resurface or replace rotors. if the vehicle shakes without applying the brakes, check tire balance.
Van shakes when braking?
Vibration when applying brakes is most likely warped rotors. Another cause could be loose caliper bolts.
Front end shakes when applying brakes on a 2001 jeep gand charkee?
2 possible issues, warped brake disc, or failing steering dampner.
What is a synonym for vibrates?
Shakes, quivers, fluctuates, reverberates, trembles, resonates, oscillates...
Your Montero shakes when you push the brakes?
Warped rotors
Why does car shake when applying brakes even though front and rear brakes rotors and drums were replaced shakes when pulling emergency brake as well bearings and tires are good?
Good question. You may have an antilock brake circuit that is not sensing the brakes correctly and improperly correcting. Anti lock pulses the brakes when you apply them. I don't know if this is perfected or not.
If the car shakes when in drive on an automatic transmission vehicle what could be wrong?
Kinda need more information. Is it just when accelerating, or also when idling in drive? Does it only do it at a certain rpm or speed, or when applying brakes?
