STEP 1
*This must be done when headlamps are cool. recommend you do this in a cool, shaded area. Clean Headlamp lens with windex, using terry cloth or sponge to remove dirt, bugs guts and any road tar.
Very dull is an adjective. (Dull is the adjective and very is an adverb.)
look in the owners manual very helpful book. or remove plastic cover and twist plastic cover where build is
There are many ways, sand-blasting, very fine sandpaper, (400 to 600 grit) for contoured plastic, a fine sandpaper flop wheel. (to name a few)
On my 2001 Jetta 1.8T, the outside of the plastic headlight housing gets yellow, probably due to UV light. I use Mother's Mag & Aluminum Polish, which removes the very thin layer of plastic (probably less than 0.001") that has yellowed.
If a plastic lens, drill a very small hole at the bottom to let water drain out. If a glass lens, you will have to replace.
This is a very dull answer to your question.
carefully pull out the plastic clips holding the headlight assembly in place, as well as the screws holding some of the top molding in place and pull out the entire headlight assembly. Don't touch the bulb (glass part) and replace the bulb, then put it all back together. be careful with the plastic clips, they break very easily
Yes very much!
the light I'd dull because led is very dull and not shiny!!
Very rock and dull it is very hard to climb
Because dull tools dont cut or do anything very well!
Very difficult unless you have very small hands. You need to remove the round plastic cover under the wheel arch by turning it anticlockwise, after turning the steering into a full lock. You then put your hand through the hole, remove another plastic cover, remove the headlight and replace it with the new one. You repeat the same thing on the other side if you are changing both. Dont forget to replace the plastic covers. I would recommend you buy the bulbs from Halfords and pay the extra to have it fitted.... It is well worth it!