You should get away with just putting a new filter drier in ,what you have to watch is the oil level in the system as the new comp should come with it's own oil ,measure oil out of old comp and subtract it from the new
If there is metal chips and trash from the old compressor in the system, yes you need to flush the system. Any trash left in the system will shorten the life of the new pump.
might need to reset the problem indicator
The compressors that come with central Ac systems are hermetically sealed and have oil inside. There is no need to add oil. If you are replacing the compressor then flush the line set first then replace, also install a filter drier.
Yes!
The ac compressorThe ac compressor
changing ac compressor only, how much oil do i add 2.7 Toyota tacoma 1999.... 6 ounces
To unseize or rebuild the AC compressor on a 2004 RX-8, you can start by attempting to free the compressor by applying penetrating oil to the pulley and rotating it manually. If the compressor is irreparably seized, you'll need to replace it, as rebuilding is often not feasible for automotive AC compressors. Ensure to replace the receiver-drier and flush the AC system to remove debris before installing a new compressor to prevent future issues. Always consider consulting a professional mechanic for a thorough assessment and proper installation.
To change the ac compressor you will have to first remove the old Freon. This needs to be reclaimed with a special machine. take care that the pressure is removed from the system before the hoses are removed.
Do y need puller to replace ac clutch on compressor. 2004 expition
The only reason to flush the ac system is if you had a compressor burn out. if this did not happen you just need to have the system recharged. you might have air the the system pull a vaccum on the system this should remove the air and the moisture. ******************************************************************* If you replace the compressor you should replace the drier and expansion valve and flush the system. To flush it you need a flush solution and clean dry compressed air. Put the solution in and force it out with the air one line at a time until the flush comes out clean. Install the new parts with the proper amount of oil and recharge the system.
yes it will.
The clutch bearing for an AC compressor is located in the center of the clutch. If the bearing goes bad, then the clutch is replaced as a whole part rather than changing the bearing.