escape 01 rear wiper dosen't work
The fluid not spraying could be a clogged line or disconnected line or bad windshield washer motor. The rear wiper not working could be a bad wiper motor in the rear or unhooked linkage or fuse or relay. Check the fuses etc first.
In the 2003 Jeep Liberty, the rear wiper switch is located on the end of the windshield wiper control stalk on the right side of the steering column. To operate the rear wiper, turn the stalk to the rear wiper position. For intermittent use, you can pull the stalk towards you to activate the rear washer. Remember to ensure the rear wiper is in the "on" position for continuous operation.
check fuses or relays
Go to Ford and buy the original equipment rear wiper--it works . I found out the hard way after buying aftermarket wipers that didn't work--twice i might add. Original equipment wiper bought from Ford worked first time--still is!!!
If the rear window is not fully closed the rear wiper will not operate.
there is most probably a wiring faulty
Disconnected or broken control linkage? Bad wiper transmission?
2003 GMC Envoy rear wiper troubleshooting - check in this order: Fuse, switch, spindle/tightness of arm, motor, wiring. See the Sources and Related Links section below for rear wiper blade information.
The rear wiper may not work due to several reasons, such as a blown fuse, a faulty wiper motor, or a malfunctioning switch. Additionally, the wiper blade could be stuck due to ice or debris, or the linkage that connects the motor to the wiper arm might be damaged. Inspecting these components can help identify the issue. If necessary, consult a professional for a thorough diagnosis and repair.
My 2003 Sienna has one tank that is for the front and rear window. You might have a problem with your pump or something else. Does your front wiper work?
the rear washer pulls from the front...fill the front end and the rear should work.
does the front wiper fluid work so its just the wiper fluid in the back that doesnt work if thats the case it might be a hose thats disconected the washer pump is shared with the front and back fluid its located on the washer fluid container at the bottom just check your hoses to make sure they are still connected i might not be explaining it right but hope this helps