Just replaced compressor on 1981 DeVille. It has 3 nuts on the bottom of the bracket in front. There is also a stud which holds the rear in place UNDER the air cleaner about 8 inches behind the compressor. You will need to remove the stud with a pair of nuts locked together. Then the compressor with brackets attached comes straight out toward the radiator. Ignition wires and other hoses and wires need to be ON TOP of the rear bracket with exception of one tube underneath. Only four fasteners need to be removed to get it off and trying to take brackets off is a waste of time. The rear bracket only goes on one way, or it will not connect to stud. Note how the bolts go through the brackets because they need to go back the same way.
remove the old one first
The headlight assembly on a 1998 Acura Integra is held on by brackets. To remove them loosen the bolts on the brackets. Pull the housings off. Install the new housings by placing them on the brackets.
Begin by removing the alternator belt. Remove the wiring harness from the back of your alternator. Remove the alternator retaining bolts. Reverse the process to install your new Cadillac alternator.
remove the right front wheel, then you can see it, tough to get at.
To install the tubular side step on the Jeep Liberty, first remove the bolts and the running boards if the vehicle has them. Then, install the side step with the mounting brackets included. You might need to drill into the frame of the vehicle to place the bolts for the brackets. Then, add the step which bolts to the mounting bracket.
Remove the connector from the back of your 2003 Cadillac parking light assembly. Take hold of the lightbulb, push in and turn at the same time to remove it. Reverse the process to install the new parking lightbulb.
Remove the wheels of the affected rotors. Remove the calipers and hang from a bungee or other strap to prevent stress on the brake hoses. Remove the caliper brackets. Remove the rotors. Clean the rust from the hub flange. Clean the anti-rust from the new rotors. Install the new rotors. Install the brackets. Install the new pads (if you are using new pads). Compress the caliper piston, one side at a time, using a c clamp or actual piston tool. Install the calipers. Install the wheels. MAKE SURE YOU PUMP UP THE PEDAL BEFORE YOU PUT THE CAR IN GEAR. Many people have taken out walls for forgetting this step.
i have a 62 cadillac,how do you remove the heater core
To replace broken blinds, first measure the window to determine the size needed. Purchase new blinds that fit the measurements. Remove the old blinds by unscrewing them from the brackets. Install the new blinds by attaching them to the brackets and adjusting them as needed.
To replace vertical blinds, first measure the width and length of your window. Purchase new blinds that match these measurements. Remove the old blinds by detaching them from the brackets. Install the new blinds by attaching them to the brackets and adjusting the length as needed.
To remove floating shelves, first, remove any items on the shelves. Then, locate the brackets or hardware holding the shelves in place. Use a screwdriver or drill to unscrew the brackets from the wall. Finally, gently lift the shelves off the brackets and remove them from the wall.
how do you remove the starter fro cadillac cts 2005