The screw on the side throttle body
If its not a PCM with electronic engine idle control. Most of today veichles you can not adjust idle. What motor do you have cummins? Like can people be a little more specific??
Pull the Spout Connector Before changing Idle Screw and make sure its up to operating temp then turn the idle screw on the Throttlebody.Replace the Spout Connector then all should be well,If you disconnect the Battery for any length of time you must remove the Spout Connector again to allow it to Relearn the Position.
The distributor rotor turns COUNTERCLOCKWISE
if it has a distributor you can.
Computer controlled If you have a 3.0 you can turn the distributor to adjust, after you pull out the adjustment chip.
Not without major modification, no.
No, not without major modification.
Wheels from 1994-2004 Mustangs will interchange with the 1995 wheels without a problem.
no cause a 1994 may have a bigger engine
Not without suspension and body modifications. 20's will fit without altering anything.
On a 1994 Ford Probe, the distributor adjustment is typically located on the distributor itself. To adjust the timing, you would need to loosen the hold-down bolt on the distributor, which allows for rotation. After achieving the desired timing adjustment, retighten the bolt to secure the distributor in place. Always use a timing light for precise adjustments.
Yes , a 1994 Ford Mustang is rear wheel drive
The 1994 Ford Mustang Cobra SVT was rated at 240-horsepower
It depends on which engine you have. The 2.2 has no distributor.