To change the side light on a Fiat Scudo van, first, ensure the vehicle is turned off and the keys are removed. Open the bonnet and locate the back of the headlight assembly. Disconnect the wiring harness from the bulb holder, twist the bulb holder counterclockwise to remove it, and replace the old bulb with a new one. Reassemble the parts by reversing the steps, ensuring everything is securely in place before closing the bonnet.
Scudo heater relay under bonnet on drivers side in fuse box
To change the rear lights on a Fiat Scudo, first, open the rear door and locate the light assembly on the side you need to replace. Remove the screws or clips securing the light assembly, then gently pull it out. Disconnect the electrical connector, replace the old bulb with a new one, and reassemble the light by reconnecting the connector and securing the assembly back in place. Finally, test the new light to ensure it works properly before closing the door.
My 2007 Citroen Dispatch is the same model as the Fiat Scudo and Peugeot Expert and the fusebox is located under the bonnet behind the battery - there is a clip on either side of the cover [push inward to undo], however, there isn't a guide to which fuse does what.
If you need the location of the fuses, my '99 scudo fuses are behind the glove box. You need to press a spring clip at either side of the open glove box and remove it completely.
The VIN (Vehicle Identification Number) on a Fiat Scudo is typically located in several places: on the driver's side dashboard, visible through the windshield, and on a label inside the driver's side door frame. It may also be found in the vehicle's registration documents. Checking these locations will help you locate the VIN easily.
i recently had same problem on fiat scudo there is a latch on drivers side it might be slightly worn i just changed it with other side its working fine now good luck
The bonnet release on a Fiat Scudo is typically located inside the vehicle, on the driver's side. You can usually find it near the lower left side of the dashboard, often near the door or under the steering wheel. It may be a lever or a pull handle that you need to pull to release the bonnet latch. After pulling the release, you may need to lift the bonnet slightly and find the safety catch to fully open it.
The EGR valve on a Fiat Scudo 1.6 is typically located near the engine's intake manifold, often on the side or rear of the engine block. To access it, you may need to remove components such as the air intake duct or other nearby parts. Always refer to the vehicle's service manual for precise location details and instructions specific to your model year.
In a 2006 Fiat Scudo, the fuse for the flasher unit is typically located in the fuse box, which can be found under the dashboard on the driver's side. You may need to remove a cover to access the fuses. Look for the specific fuse labeled for the turn signals or flasher; it is usually a small blade-type fuse. Always refer to the vehicle's owner manual for the exact fuse location and specifications.
The washer bottle on a Fiat Scudo is typically located in the engine compartment, near the back of the engine bay on the driver's side. It is usually a translucent plastic container with a cap marked for windshield washer fluid. To access it, you may need to open the hood and look for the bottle, which often has a symbol indicating its purpose. Always refer to the vehicle's owner's manual for specific details related to your model year.
Depends on the model. The injection pump on the side of the engine also acts as the fuel pump on non turbo Scudos. Turbo engines also have a pump in the fuel tank. Fuel tank removal is requrired to gain access to this pump.
changeing side light bulb