To remove motor oil from flagstone, start by absorbing as much of the oil as possible using paper towels or rags. Then, sprinkle a generous amount of baking soda or cat litter over the stain to absorb the remaining oil, allowing it to sit for several hours or overnight. Afterward, scrub the area with a mixture of warm water and dish soap, using a stiff brush to work the solution into the stone. Rinse thoroughly with water to remove any residue and repeat the process if necessary.
could be oil burn off from the leak Or during repair, the relative dripped oil on the motor, and the excess is burning off when the motor gets hot!
A great way to get motor oil off your hands is to use olive oil: Squirt some olive oil on your hands, rub your hands together to get the motor oil dissolved, then use soap to remove the mixture. Works great, doesn't leave your skin dry and irritated like solvents do.
If the motor is healthy, the oil will burn off in a moment or two.
you have to pull the motor and when you get the motor pulled take the oil pan off and the oil pump is in there ity will have a tube with a screen on it good luck
purple power or any degreaser
I was thinking about adding some Flagstone Pavers next to my driveway. Do you know if Lowe's sells Flagstone Pavers?
you will have to raise the motor up by taking the motor loose at the mounts just enough to get the oil pan off.
decreased temperature
You have to hoist the motor up just enough to get it off take the motor mount nuts off there is a filter inside the oil pan tht is holding it
I need a sidewalk from my porch to the street. Can it be made from flagstone pavers?
No, acetone is not a solvent for oil. If motor oil or similar, use gasoline first, then Goof-Off to finish.
No you do not , But it's one hell of a job to get off.