0
To remove the spare tire from a 2008 Fiat Ducato van, first, locate the spare tire compartment, which is typically found underneath the rear of the vehicle. Use the provided jack handle or a wrench to loosen the securing mechanism, usually a winch or bolt, that holds the tire in place. Once loosened, carefully lower the spare tire down and detach it from the securing system. Finally, lift the spare tire out and store it safely.
What else can I help you with?
When was Fiat Ducato created?
Fiat Ducato was created in 1981.
Fiat ducato 2.3 jtd?
how to top up fiat ducato gearbox
Where is glow plug relay on Fiat ducato?
Where is the glowplug relay on a fiat ducato 2003 1.9
What does a fiat ducato weigh lwb med roof and what can is it rated to carry?
what is the weight of fiat ducato 2.8
Where is the starter battery on a 2008 Fiat Ducato?
Under a panel in the floor in front of the passengers seat
Fan not working on Fiat ducato?
There's a relay and fuse in the fuse box in the engine compartment.
When was the Fiat Ducato first produced?
The first Fiat Ducato was produced in 1981. Since then more than two point four million Fiat Ducato vehicles have been produced. It is the most common motor home in Europe.
What gear oil for a fiat ducato 2.8td?
what gearbox oil for ducato 2.8 jtd
Where are the glow plugs on a Fiat ducato?
I have a Fiat Ducato 2.5td on a 1997 plate. It does not have glow plugs.Just a Thermo Start on top of the manifold, this is similar in looks to a glow plug but is easier to get to. Be careful as you have to remove the Fuel pipe from the Thermo Plug, take you time.Hope this helps.
How do you change thermostat on a Fiat ducato?
tony
Where is the fuse box on a fiat ducato 1994?
in glove box
How do you remove clutch on a Fiat ducato 1.9td?
To remove the clutch on a Fiat Ducato 1.9 TD, first, disconnect the battery and secure the vehicle on a level surface. Remove the transmission by detaching the drive shafts, gear linkages, and any electrical connectors. Once the transmission is out, unbolt the pressure plate and flywheel to access the clutch disc. Finally, replace the clutch components as necessary before reassembling.
